Log into your Prepaway Account
Please Log In to download ETE file or view Training Course
Registration is free and easy - just provide your E-mail address.
Click Here to Register
Exam: | 300-135 - CCNP Troubleshooting and Maintaining Cisco IP Networks (TSHOOT v2.0) |
Size: | 8 MB |
Posted: | Friday, September 29, 2017 |
Download:
|
Cisco.Real-exams.300-135.v2017-09-29.by.eric.68q.ete |
Download Free 300-135 Exam Questions |
Log in to make your opinion count.
Registration is free and easy - just provide your E-mail address.
Click Here to Register
Use Discount Code:
A confirmation link was sent to your e-mail.
Please check your mailbox for a message from [email protected] and follow the directions.
many questions about IPV6
first you've to specify which device has an issue, then check where is the fault in device configuration..
tracert is not allowed, only you can use ping.
the tickets that related to IPV6; it's hard to find the issue using ping, so you've to check where is the fault device by device.
inside the ticket under 'where is the fault' if you select wrong device the choices will be changed on next secreen based on your selection and the whole ticket will become wrong.
When you take the exam how are the Tickets displayed?
Do you see The Topology and all the 3 subquestions of the ticket on the same screen? so you can just navigate through the questions? like is it possible to answer question 3 first and then question 1 of the ticket? ....and when your done you go to the next Ticket...
Or is it like you see the Topology and you have to answer the Tickets subsquestions 1 by 1 without the option to click back?
the topology is same for all tickets but the config is changing so fault is changing accordingly.
do your ping,sh commands until you are 100% sure you got the device where the fault is,once this is done, compare the config of devices before & after the faulty device and rely on commands to give a hint about the problem, neighbor relations, ip route table etc...
best luck everyone
Configuration on R4
router eigrp 1 <——-1
network 10.1.4.5 0.0.0.0
no auto-summary
redistribute ospf 1 <——-2
1 is the problem in the question but 2 is not right either so I think the dump is little incorrect in some question.
6 MCQs, EIGRP
During the examination, it works like this ...
1. Choose the device
2. Choose the service (ipv4, ipv6, dhcp, etc.)
3. Choose the correct sentence.
I reproached last week because I had this knowledge.
Could you please explain, how many new tickets you got ??
Kabali24Theri November 25th, 2017
Pass my exam with full marks.
At the beginning i was confused with the question view, there is multiple tab on the button i was referring to the scenario explanation since not aware the question is on the Ticket Tab.
Ticket Tab question all is the same beside IPv6 question so if the Host/PC1 able to reach the web server confirm is a IPv6 issue, but again take time to read the Ticket Tab option.
Sim Q is on the main ticket listed 1..2..3..4.. so be aware
i got following Q
ASW1
====
Port security
Access Vlan
Switch to Switch
DSW1
====
VLAN ACL
R4
==
IPv4 OSPF routing
IP EIGRP route (passive interface)
IPv4 Route Redistribution
R3
==
IPv4 and Ipv6 inter
R2
==
Ipv6 OSPF routing
R1
==
BGP
IP NAT
IPv4 layer 3 Security
IP OSPF routing
For ASW1 issue PC1 still get DHCP ip address, best way is to memories the Answer for each router and switch issue and written down before start the exam, upon completion you mark the Q done, so u will know what’s left out, to save time and peace of mind.
I practice 2 dumbs below.
I guess by.Maya.65q.ete 2 Question incorrect.
Correct ans:
1)DWS1 ACL/vlan filter test1 vlan-list 10
2)Switch Sim SW4 doesn´t have the VLAN200 (can't recall)
Keep in mind ans 1) to 3) should be accurate to get full marks.
Example:
Ticket 11 – OSPF to EIGRP
Ans1) R4
Ans2) IPv4 Route Redistribution
Ans3) Under the EIGRP process, delete the redistribute ospf 1 route-map OSPF_to_EIGRP command and enter the redistribute ospf 1 route-map OSPF->EIGRP command.
Ans 2) if you mention (IPv4 EIGRP is wrong)
I Passed before yesterday with 903/1000.
Very good!
All question is the same!!!
Attention and calm in the moment execute the tshoot of problems..
Good Luck Guys!
For the tickets, ping and traceroute are ur best tools. See where it fails and tshoot from there as tickets have same descriptions and the questions change based on ur answers.
There is no changes it is the same dumps. Passed the exam with score 951/1000 Today 4/11/2017. The exam is still the same, had the same 13 tickets, 2 simlets with 4 questions each (HSRP & SWITCH) and the 6 MCQs.
Good luck guys
I have one Question Wrong in Layer 2
some tickets is same just be carful
14 Tkts
1 Eigrp Simlet
6 MCQ’s
the switch to switch trunk issue shows Vlan 20 and 200 are allowed on ASW1. check this out while troubleshooting the switch to switch trunk vlan allowed.
all of ppl say they got 13 tickets. and you say you got 14 tickets so can you tell us what was the no 14 ticket?
2h time and 850/1000 passing score.
Good luck.
Must prepare from Networktut too.
Cheers.
Examine the configuration on R5. Router R5 do not see any route entries learned from R4; what could be the issue?
I'm preparing to take the exam next week and I'm just using show run command to solve questions.Is there anything wrong with this?
Please share the 300-135 Tshoot latest dump to [email protected]
Thanks
For those about to take exam - make sure you understand concepts, try dumps and test lab on networktut.com
Please send me on
[email protected]
Command which are not working is.
Show Running Interface Fastethernet
Show Access-list
sh ip ospf/eigrp interface brief
sh running-configuration | sec
traceroute is not working from client
ipconfig /all not working
Well done! If you could send me the dump at [email protected]?
Cheers
Congratulation! could you please send me the valid dumps pdf on [email protected].
please advise.
Please,can you send valid dump to [email protected]
Thank you
Can u send me the passleader exam? My email is [email protected]. Appreciated it a lot. Thanks
Please share the 300-135 Tshoot latest dump to [email protected]
Thanks
Congratulation could you please send me the valid dumps on [email protected]
This dump is valid. I passed
Well done! If you could send me the dump at [email protected]?
Cheers
Congratulation! Need Help, could you please send me the valid dumps on [email protected]
I'll be very garteful
Please share the latest 300-135 tshoot dump to [email protected]
Thanks
pass today score 951
good luck
Total 21 questions, 6 MCQs, 2 SIMs (EIGRP & HSRP), 13 Tickets (no EIGRP-AS & DHCP & HSRP).
All the exam questions were came from passleader 300-135 dumps!
Good Luck for All!
Thank you
Could you please send me The valid dump to [email protected]
Thank you
thank you.
100% valid. Good luck for all
Can you send me this valid dump to [email protected]