Test Prep ASVAB Test Practice Test 36
Question 350
If f(t) = 2t² - 3t + 4, what is f(8)?
- 108
- 124
- -4
- 44
Explanation
Correct Answer
A:Best answer. Substitute t=8: 2(8²) - 3(8) + 4 = 108. This is the concept directly requested by the question.
Incorrect Answers
B:Not best. The proposed value 124 comes from an incorrect operation or an incorrect interpretation of the given quantities. Substitute t=8: 2(8²) - 3(8) + 4 = 108.
C:Not best. The proposed value -4 comes from an incorrect operation or an incorrect interpretation of the given quantities. Substitute t=8: 2(8²) - 3(8) + 4 = 108.
D:Not best. The proposed value 44 comes from an incorrect operation or an incorrect interpretation of the given quantities. Substitute t=8: 2(8²) - 3(8) + 4 = 108.
Question 351
Which unit is used to measure electrical resistance?
- Ampere
- Ohm
- Watt
- Volt
Explanation
Correct Answer
B:Best answer. Resistance is measured in ohms. This is the concept directly requested by the question.
Incorrect Answers
A:Not best. Ampere: Amperes measure electric current. It does not meet the specific requirement in the question.
C:Not best. Watt: Watts measure electrical power. It does not meet the specific requirement in the question.
D:Not best. Volt: Volts measure electric potential difference.
Question 352
Which unit is used for electric current?
- Ampere
- Ohm
- Farad
- Hertz
Explanation
Correct Answer
A:Best answer. Electric current is measured in amperes. This is the concept directly requested by the question.
Incorrect Answers
B:Not best. Ohm: Ohms measure resistance. It does not meet the specific requirement in the question.
C:Not best. Farad: Farads measure capacitance. It does not meet the specific requirement in the question.
D:Not best. Hertz: Hertz measures cycles per second. It does not meet the specific requirement in the question.
Question 353
What does a fuse mainly protect against?
- Low-frequency noise
- Unexpected polarity reversal in every case
- Excessive current
- Low illumination
Explanation
Correct Answer
C:Best answer. A fuse melts and opens when current exceeds its rated condition.
Incorrect Answers
A:Not best. Low-frequency noise: A fuse does not filter radio-frequency interference.
B:Not best. Unexpected polarity reversal in every case: Fuses are not universal reverse-polarity protection.
D:Not best. Low illumination: Light intensity is unrelated to circuit fusing.
Question 354
What is the primary behavior of an ordinary diode?
- It converts all AC to DC without a circuit
- It stores mechanical energy
- It always increases frequency
- It conducts much more readily in one direction
Explanation
Correct Answer
D:Best answer. A diode's junction favors forward-biased conduction.
Incorrect Answers
A:Not best. It converts all AC to DC without a circuit: A single diode provides half-wave rectification only.
B:Not best. It stores mechanical energy: Mechanical springs store elastic energy.
C:Not best. It always increases frequency: A diode does not inherently raise frequency.
Question 355
Which component stores energy in an electric field?
- Fuse
- Inductor
- Resistor
- Capacitor
Explanation
Correct Answer
D:Best answer. A capacitor stores charge separated by a dielectric.
Incorrect Answers
A:Not best. Fuse: A fuse opens a circuit during overcurrent.
B:Not best. Inductor: An inductor stores energy in a magnetic field.
C:Not best. Resistor: An ideal resistor dissipates electrical energy.
Question 356
Which component stores energy in a magnetic field?
- Switch
- Capacitor
- Inductor
- Resistor
Explanation
Correct Answer
C:Best answer. Current through an inductor produces a magnetic field and stored energy.
Incorrect Answers
A:Not best. Switch: A switch controls conduction paths. It does not meet the specific requirement in the question.
B:Not best. Capacitor: A capacitor stores energy in an electric field.
D:Not best. Resistor: A resistor dissipates electrical energy.
Question 357
What happens to an open switch in a simple series circuit?
- It interrupts current
- It provides a zero-ohm short
- It reverses supply polarity
- It doubles current
Explanation
Correct Answer
A:Best answer. An open switch breaks the conducting path.
Incorrect Answers
B:Not best. It provides a zero-ohm short: A short is an unintended low-resistance path.
C:Not best. It reverses supply polarity: Opening a switch does not reverse a power supply.
D:Not best. It doubles current: An open circuit prevents current in an ideal series loop.
Question 358
What do parallel-connected loads share in an ideal circuit?
- The same current regardless of resistance
- The same voltage
- The same resistance in all branches
- The same individual power consumption
Explanation
Correct Answer
B:Best answer. Each branch connects across the same two nodes.
Incorrect Answers
A:Not best. The same current regardless of resistance: Branch currents can differ.
C:Not best. The same resistance in all branches: Branch values need not match.
D:Not best. The same individual power consumption: Power depends on each branch impedance.
Question 359
In a series circuit, what quantity is the same through each element?
- Voltage across each resistor
- Resistance of each component
- Current
- Temperature of each component
Explanation
Correct Answer
C:Best answer. One uninterrupted series path carries the same current.
Incorrect Answers
A:Not best. Voltage across each resistor: Voltage divides according to resistance.
B:Not best. Resistance of each component: Series components may have different values.
D:Not best. Temperature of each component: Heating may differ between parts.
Question 360
Which instrument measures voltage when connected across two nodes?
- Tachometer
- Voltmeter
- Hygrometer
- Ammeter in series only
Explanation
Correct Answer
B:Best answer. A voltmeter is connected in parallel with the points of interest.
Incorrect Answers
A:Not best. Tachometer: A tachometer measures rotational speed.
C:Not best. Hygrometer: A hygrometer measures humidity. It does not meet the specific requirement in the question.
D:Not best. Ammeter in series only: An ammeter measures current through a path.