cert
cert-1
cert-2

Pass CompTIA N10-009 Exam in First Attempt Guaranteed!

Get 100% Latest Exam Questions, Accurate & Verified Answers to Pass the Actual Exam!
30 Days Free Updates, Instant Download!

cert-5
cert-6
N10-009 Exam - Verified By Experts
N10-009 Premium Bundle
$29.98

N10-009 Premium Bundle

$79.99
$109.97
  • Premium File 768 Questions & Answers. Last update: Nov 13, 2026
  • Training Course 240 Video Lectures
  • Study Guide 128 Pages
 
$109.97
$79.99
accept 176 downloads in last 7 days
block-screenshots
Purchase CompTIA N10-009 Exam Training Products Individually
CompTIA N10-009 Premium File
Premium File 768 Q&A
$76.99$69.99
CompTIA N10-009 Video Training Course
Training Course 240 Lectures
$21.99 $19.99
CompTIA N10-009 PDF Study Guide
Study Guide 128 Pages
$21.99 $19.99
CompTIA N10-009 Practice Test 80

Question 790

A switch reports unexpected MAC flapping between uplink ports and the engineer must identify the source VLAN. A colleague instead suggests: Rely only on a DNS AAAA lookup for MAC learning instability. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. Layer 3 route selection needs routing tools rather than MAC-only tables.
  2. DNS AAAA records concern IPv6 name resolution, not switch forwarding state.
  3. MAC table and VLAN commands identify where layer-2 addresses are learned.
  4. Cable toners do not measure radio channels and signal strengths.

Explanation

Correct Answer

B:

DNS AAAA records concern IPv6 name resolution, not switch forwarding state. This flaw directly concerns the proposed action: Rely only on a DNS AAAA lookup for MAC learning instability.

Incorrect Answers

A:

This rationale belongs to a later changed condition: The fault moves to a routed network with incorrect gateway choice.

C:

This explains why the recommended control works: Use show mac-address-table and show vlan with spanning-tree status checks.

D:

This flaw concerns a different case in objective 5.5: A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room. The current rejected proposal is: Rely only on a DNS AAAA lookup for MAC learning instability.

Question 791

A switch reports unexpected MAC flapping between uplink ports and the engineer must identify the source VLAN. After applying the solution 'Use show mac-address-table and show vlan with spanning-tree status checks.', which observation MOST directly proves that the requirement was met?

  1. Queries from the expected resolver return the intended record and service resolves.
  2. The affected VLAN and competing ports are identified and the loop corrected.
  3. Survey results associate weak service with measured coverage or channel contention.
  4. Approval is recorded for 'Use show mac-address-table and show vlan with spanning-tree status checks.' but no operational validation is performed.

Explanation

Correct Answer

B:

The affected VLAN and competing ports are identified and the loop corrected. It tests the intended outcome because mac table and vlan commands identify where layer-2 addresses are learned.

Incorrect Answers

A:

This test addresses a separate problem: An administrator suspects DNS is returning the wrong IP for one service but raw IP reachability works.

C:

This observation is for a different condition: A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room. It does not directly test the target outcome: A switch reports unexpected MAC flapping between uplink ports and the engineer must identify the source VLAN.

D:

The missing direct test is: The affected VLAN and competing ports are identified and the loop corrected.

Question 792

The original case was: A switch reports unexpected MAC flapping between uplink ports and the engineer must identify the source VLAN. The requirement then changes: The fault moves to a routed network with incorrect gateway choice. Which revised action BEST meets this new condition?

  1. Use show mac-address-table and show vlan with spanning-tree status checks.
  2. Rely only on a DNS AAAA lookup for MAC learning instability.
  3. Inspect show route and next-hop reachability on routers.
  4. The affected VLAN and competing ports are identified and the loop corrected.

Explanation

Correct Answer

C:

Layer 3 route selection needs routing tools rather than MAC-only tables. The revised requirement is: The fault moves to a routed network with incorrect gateway choice. The appropriate action is: Inspect show route and next-hop reachability on routers.

Incorrect Answers

A:

This is the original control. MAC table and VLAN commands identify where layer-2 addresses are learned. It does not directly satisfy the revised requirement: The fault moves to a routed network with incorrect gateway choice.

B:

DNS AAAA records concern IPv6 name resolution, not switch forwarding state. It remains inappropriate in the revised context.

D:

The affected VLAN and competing ports are identified and the loop corrected. The current requirement is: The fault moves to a routed network with incorrect gateway choice.

Question 793

A technician needs to verify whether an edge switch has enough PoE capacity for newly installed cameras. Which action MOST directly meets the stated networking requirement?

  1. Query authoritative and recursive answers with dig or nslookup and compare TTL and records.
  2. Use traceroute to infer the amount of unused electrical power.
  3. Use show power or platform PoE diagnostics and compare draw to budget.
  4. Check cabling, port status and device boot logs.

Explanation

Correct Answer

C:

PoE power diagnostics show delivered watts and available switch headroom. This specifically resolves: A technician needs to verify whether an edge switch has enough PoE capacity for newly installed cameras.

Incorrect Answers

A:

This addresses another problem in objective 5.5: An administrator suspects DNS is returning the wrong IP for one service but raw IP reachability works.

B:

Path probes do not measure PoE capacity. The suggested approach is: Use traceroute to infer the amount of unused electrical power.

D:

This action responds to a later condition: A camera stays offline even though power diagnostics are sufficient. A powered device may fail for reasons unrelated to overall PoE budget.

Question 794

A technician needs to verify whether an edge switch has enough PoE capacity for newly installed cameras. A colleague instead suggests: Use traceroute to infer the amount of unused electrical power. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. PoE power diagnostics show delivered watts and available switch headroom.
  2. Path probes do not measure PoE capacity.
  3. A toner locates physical conductors and cannot query DNS records.
  4. A powered device may fail for reasons unrelated to overall PoE budget.

Explanation

Correct Answer

B:

Path probes do not measure PoE capacity. This flaw directly concerns the proposed action: Use traceroute to infer the amount of unused electrical power.

Incorrect Answers

A:

This explains why the recommended control works: Use show power or platform PoE diagnostics and compare draw to budget.

C:

This flaw concerns a different case in objective 5.5: An administrator suspects DNS is returning the wrong IP for one service but raw IP reachability works. The current rejected proposal is: Use traceroute to infer the amount of unused electrical power.

D:

This rationale belongs to a later changed condition: A camera stays offline even though power diagnostics are sufficient.

Question 795

A technician needs to verify whether an edge switch has enough PoE capacity for newly installed cameras. After applying the solution 'Use show power or platform PoE diagnostics and compare draw to budget.', which observation MOST directly proves that the requirement was met?

  1. Traces and route entries isolate the first suspected forwarding failure.
  2. Power values and actual camera startup remain within the rated budget.
  3. Approval is recorded for 'Use show power or platform PoE diagnostics and compare draw to budget.' but no operational validation is performed.
  4. Queries from the expected resolver return the intended record and service resolves.

Explanation

Correct Answer

B:

Power values and actual camera startup remain within the rated budget. It tests the intended outcome because poe power diagnostics show delivered watts and available switch headroom.

Incorrect Answers

A:

This test addresses a separate problem: A remote subnet is unreachable and an engineer needs to identify where packets stop along the route.

C:

Approval alone does not demonstrate operating effectiveness. The missing direct test is: Power values and actual camera startup remain within the rated budget.

D:

This observation is for a different condition: An administrator suspects DNS is returning the wrong IP for one service but raw IP reachability works. It does not directly test the target outcome: A technician needs to verify whether an edge switch has enough PoE capacity for newly installed cameras.

Question 796

The original case was: A technician needs to verify whether an edge switch has enough PoE capacity for newly installed cameras. The requirement then changes: A camera stays offline even though power diagnostics are sufficient. Which revised action BEST meets this new condition?

  1. Power values and actual camera startup remain within the rated budget.
  2. Check cabling, port status and device boot logs.
  3. Use traceroute to infer the amount of unused electrical power.
  4. Use show power or platform PoE diagnostics and compare draw to budget.

Explanation

Correct Answer

B:

A powered device may fail for reasons unrelated to overall PoE budget. The revised requirement is: A camera stays offline even though power diagnostics are sufficient. The appropriate action is: Check cabling, port status and device boot logs.

Incorrect Answers

A:

Power values and actual camera startup remain within the rated budget. The current requirement is: A camera stays offline even though power diagnostics are sufficient.

C:

This action was already unsuitable. Path probes do not measure PoE capacity. It remains inappropriate in the revised context.

D:

This is the original control. PoE power diagnostics show delivered watts and available switch headroom. It does not directly satisfy the revised requirement: A camera stays offline even though power diagnostics are sufficient.

Question 797

A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room. Which action MOST directly meets the stated networking requirement?

  1. Use a copper toner as a spectrum analyzer for 6GHz Wi-Fi.
  2. Use traceroute or tracert with context from routing-table checks.
  3. Capture DHCP exchange or inspect server scope and relay.
  4. Use a Wi-Fi analyzer or approved RF survey software to inspect channel and signal distribution.

Explanation

Correct Answer

D:

Wireless analyzers identify channel overlap and coverage patterns not shown by simple IP tests. This specifically resolves: A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room.

Incorrect Answers

A:

Cable toners do not measure radio channels and signal strengths. The suggested approach is: Use a copper toner as a spectrum analyzer for 6GHz Wi-Fi.

B:

This addresses another problem in objective 5.5: A remote subnet is unreachable and an engineer needs to identify where packets stop along the route.

C:

This action responds to a later condition: The radio is healthy but users still cannot obtain DHCP leases. IP address allocation is a separate protocol troubleshooting layer.

Question 798

A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room. A colleague instead suggests: Use a copper toner as a spectrum analyzer for 6GHz Wi-Fi. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. IP address allocation is a separate protocol troubleshooting layer.
  2. Wireless analyzers identify channel overlap and coverage patterns not shown by simple IP tests.
  3. DNS text records do not trace router behavior.
  4. Cable toners do not measure radio channels and signal strengths.

Explanation

Correct Answer

D:

Cable toners do not measure radio channels and signal strengths. This flaw directly concerns the proposed action: Use a copper toner as a spectrum analyzer for 6GHz Wi-Fi.

Incorrect Answers

A:

This rationale belongs to a later changed condition: The radio is healthy but users still cannot obtain DHCP leases.

B:

This explains why the recommended control works: Use a Wi-Fi analyzer or approved RF survey software to inspect channel and signal distribution.

C:

This flaw concerns a different case in objective 5.5: A remote subnet is unreachable and an engineer needs to identify where packets stop along the route. The current rejected proposal is: Use a copper toner as a spectrum analyzer for 6GHz Wi-Fi.

Question 799

A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room. After applying the solution 'Use a Wi-Fi analyzer or approved RF survey software to inspect channel and signal distribution.', which observation MOST directly proves that the requirement was met?

  1. Survey results associate weak service with measured coverage or channel contention.
  2. Traces and route entries isolate the first suspected forwarding failure.
  3. The capture shows reset direction, port and sequence in the affected flow.
  4. Approval is recorded for 'Use a Wi-Fi analyzer or approved RF survey software to inspect channel and signal distribution.' but no operational validation is performed.

Explanation

Correct Answer

A:

Survey results associate weak service with measured coverage or channel contention. It tests the intended outcome because wireless analyzers identify channel overlap and coverage patterns not shown by simple ip tests.

Incorrect Answers

B:

This observation is for a different condition: A remote subnet is unreachable and an engineer needs to identify where packets stop along the route. It does not directly test the target outcome: A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room.

C:

This test addresses a separate problem: A security engineer needs a packet-level record of a TCP reset sequence during a client-to-server failure.

D:

The missing direct test is: Survey results associate weak service with measured coverage or channel contention.

Question 800

A wireless investigator needs a map of neighboring SSIDs, channels and approximate RSSI around a meeting room. Which THREE entries correctly identify the applicable control, its technical principle, and a direct validation observation? (Select THREE.)

  1. Capture DHCP exchange or inspect server scope and relay.
  2. Use a Wi-Fi analyzer or approved RF survey software to inspect channel and signal distribution.
  3. Wireless analyzers identify channel overlap and coverage patterns not shown by simple IP tests.
  4. Use traceroute or tracert with context from routing-table checks.
  5. Use a copper toner as a spectrum analyzer for 6GHz Wi-Fi.
  6. Survey results associate weak service with measured coverage or channel contention.

Explanation

Correct Answers

B:

Correct control. Wireless analyzers identify channel overlap and coverage patterns not shown by simple IP tests. It is the recommended implementation for this case.

C:

Correct principle. Wireless analyzers identify channel overlap and coverage patterns not shown by simple IP tests. This is the justification for the selected network control: Use a Wi-Fi analyzer or approved RF survey software to inspect channel and signal distribution.

F:

Correct validation. Survey results associate weak service with measured coverage or channel contention. This is the directly measurable result of the control.

Incorrect Answers

A:

This belongs to the changed condition, not the current three-part answer: The radio is healthy but users still cannot obtain DHCP leases. IP address allocation is a separate protocol troubleshooting layer.

D:

This is another scenario's control in the same domain: A remote subnet is unreachable and an engineer needs to identify where packets stop along the route. It is not the best action for this case.

E:

This control is invalid here. Cable toners do not measure radio channels and signal strengths. It does not meet the specified requirement.

CompTIA Network+ (N10-009) Practice Tests