CompTIA N10-009 Practice Test 69
Question 680
The original case was: A new optic shows low receive light power and a rising bit error rate despite matching nominal speed. The requirement then changes: A replacement optic is overdriving a very short fiber segment. Which revised action BEST meets this new condition?
- Modify an application firewall rule to increase incoming photons.
- Check supported receiver power range and use appropriate optics or attenuation.
- Measure optical power and inspect connector cleanliness, bends and link distance.
- Cleaning or replacing the bad segment restores receive power and stable frames.
Explanation
Correct Answer
B:Excess optical power can also exceed transceiver operating limits. The revised requirement is: A replacement optic is overdriving a very short fiber segment. The appropriate action is: Check supported receiver power range and use appropriate optics or attenuation.
Incorrect Answers
A:Firewall policy cannot correct optical signal attenuation. It remains inappropriate in the revised context.
C:This is the original control. Optical loss and low power can cause errors without total link failure. It does not directly satisfy the revised requirement: A replacement optic is overdriving a very short fiber segment.
D:Cleaning or replacing the bad segment restores receive power and stable frames. The current requirement is: A replacement optic is overdriving a very short fiber segment.
Question 681
An old cable run displays frequent runts and duplex-related collision counters on a legacy shared segment. Which action MOST directly meets the stated networking requirement?
- Match optical module specification, wavelength and fiber class at both ends.
- Verify duplex negotiation and investigate malformed or undersized Ethernet frames.
- Check MTU consistency and monitor actual frame lengths end to end.
- Increase the IP route's administrative distance to repair Ethernet frame length.
Explanation
Correct Answer
B:Runts and collisions can reflect PHY and duplex configuration faults. This specifically resolves: An old cable run displays frequent runts and duplex-related collision counters on a legacy shared segment.
Incorrect Answers
A:This addresses another problem in objective 5.2: A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type.
C:This action responds to a later condition: An unexpectedly large number of giant frames now appears on a jumbo-frame link. Oversized frames require a different MTU-related investigation.
D:Route preference does not correct Layer 2 frame formation. The suggested approach is: Increase the IP route's administrative distance to repair Ethernet frame length.
Question 682
An old cable run displays frequent runts and duplex-related collision counters on a legacy shared segment. A colleague instead suggests: Increase the IP route's administrative distance to repair Ethernet frame length. Which finding MOST specifically explains why that suggestion is unsuitable?
- Route preference does not correct Layer 2 frame formation.
- Address leases cannot fix an absent optical link.
- Runts and collisions can reflect PHY and duplex configuration faults.
- Oversized frames require a different MTU-related investigation.
Explanation
Correct Answer
A:Route preference does not correct Layer 2 frame formation. This flaw directly concerns the proposed action: Increase the IP route's administrative distance to repair Ethernet frame length.
Incorrect Answers
B:This flaw concerns a different case in objective 5.2: A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type. The current rejected proposal is: Increase the IP route's administrative distance to repair Ethernet frame length.
C:This explains why the recommended control works: Verify duplex negotiation and investigate malformed or undersized Ethernet frames.
D:This rationale belongs to a later changed condition: An unexpectedly large number of giant frames now appears on a jumbo-frame link.
Question 683
An old cable run displays frequent runts and duplex-related collision counters on a legacy shared segment. After applying the solution 'Verify duplex negotiation and investigate malformed or undersized Ethernet frames.', which observation MOST directly proves that the requirement was met?
- Compatible modules establish the intended rate with acceptable receive power.
- After correcting interface settings, runt and collision counters stabilize.
- Approval is recorded for 'Verify duplex negotiation and investigate malformed or undersized Ethernet frames.' but no operational validation is performed.
- Optical light measurements and link status become healthy after polarity correction.
Explanation
Correct Answer
B:After correcting interface settings, runt and collision counters stabilize. It tests the intended outcome because runts and collisions can reflect phy and duplex configuration faults.
Incorrect Answers
A:This observation is for a different condition: A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type. It does not directly test the target outcome: An old cable run displays frequent runts and duplex-related collision counters on a legacy shared segment.
C:The missing direct test is: After correcting interface settings, runt and collision counters stabilize.
D:This test addresses a separate problem: A newly installed fiber pair has no link because transmit and receive strands are reversed at one patch panel.
Question 684
The original case was: An old cable run displays frequent runts and duplex-related collision counters on a legacy shared segment. The requirement then changes: An unexpectedly large number of giant frames now appears on a jumbo-frame link. Which revised action BEST meets this new condition?
- Verify duplex negotiation and investigate malformed or undersized Ethernet frames.
- Increase the IP route's administrative distance to repair Ethernet frame length.
- Check MTU consistency and monitor actual frame lengths end to end.
- After correcting interface settings, runt and collision counters stabilize.
Explanation
Correct Answer
C:Oversized frames require a different MTU-related investigation. The revised requirement is: An unexpectedly large number of giant frames now appears on a jumbo-frame link. The appropriate action is: Check MTU consistency and monitor actual frame lengths end to end.
Incorrect Answers
A:This is the original control. Runts and collisions can reflect PHY and duplex configuration faults. It does not directly satisfy the revised requirement: An unexpectedly large number of giant frames now appears on a jumbo-frame link.
B:Route preference does not correct Layer 2 frame formation. It remains inappropriate in the revised context.
D:After correcting interface settings, runt and collision counters stabilize. The current requirement is: An unexpectedly large number of giant frames now appears on a jumbo-frame link.
Question 685
A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope. Which action MOST directly meets the stated networking requirement?
- Validate the configured default gateway and routing table.
- Check access VLAN membership, relay target and DHCP scope configuration.
- Change only the browser proxy configuration on that device.
- Verify that its default gateway belongs to the connected subnet and answers ARP.
Explanation
Correct Answer
B:A wrong VLAN or relay can direct clients to unintended addressing services. This specifically resolves: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope.
Incorrect Answers
A:This action responds to a later condition: A correct address is assigned but the workstation still cannot reach other subnets. Address assignment and gateway reachability are separate problems.
C:Application proxy settings cannot choose the proper subnet lease source. The suggested approach is: Change only the browser proxy configuration on that device.
D:This addresses another problem in objective 5.3: A client can reach hosts in its own VLAN but cannot reach any remote subnet after an addressing change.
Question 686
A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope. A colleague instead suggests: Change only the browser proxy configuration on that device. Which finding MOST specifically explains why that suggestion is unsuitable?
- Name resolution cannot repair routing to remote raw IP addresses.
- Application proxy settings cannot choose the proper subnet lease source.
- Address assignment and gateway reachability are separate problems.
- A wrong VLAN or relay can direct clients to unintended addressing services.
Explanation
Correct Answer
B:Application proxy settings cannot choose the proper subnet lease source. This flaw directly concerns the proposed action: Change only the browser proxy configuration on that device.
Incorrect Answers
A:This flaw concerns a different case in objective 5.3: A client can reach hosts in its own VLAN but cannot reach any remote subnet after an addressing change. The current rejected proposal is: Change only the browser proxy configuration on that device.
C:This rationale belongs to a later changed condition: A correct address is assigned but the workstation still cannot reach other subnets.
D:This explains why the recommended control works: Check access VLAN membership, relay target and DHCP scope configuration.
Question 687
A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope. After applying the solution 'Check access VLAN membership, relay target and DHCP scope configuration.', which observation MOST directly proves that the requirement was met?
- Approval is recorded for 'Check access VLAN membership, relay target and DHCP scope configuration.' but no operational validation is performed.
- VLAN and DHCP diagnostics confirm the client gets an address from the correct scope.
- The client reaches an external test IP after correcting its gateway.
- Packet capture shows traffic to remote subnets now forwarded to the gateway.
Explanation
Correct Answer
B:VLAN and DHCP diagnostics confirm the client gets an address from the correct scope. It tests the intended outcome because a wrong vlan or relay can direct clients to unintended addressing services.
Incorrect Answers
A:The missing direct test is: VLAN and DHCP diagnostics confirm the client gets an address from the correct scope.
C:This observation is for a different condition: A client can reach hosts in its own VLAN but cannot reach any remote subnet after an addressing change. It does not directly test the target outcome: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope.
D:This test addresses a separate problem: A server's subnet mask is accidentally set to /16 rather than /24 and it ARPs for remote hosts that should be routed.
Question 688
The original case was: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope. The requirement then changes: A correct address is assigned but the workstation still cannot reach other subnets. Which revised action BEST meets this new condition?
- Change only the browser proxy configuration on that device.
- VLAN and DHCP diagnostics confirm the client gets an address from the correct scope.
- Check access VLAN membership, relay target and DHCP scope configuration.
- Validate the configured default gateway and routing table.
Explanation
Correct Answer
D:Address assignment and gateway reachability are separate problems. The revised requirement is: A correct address is assigned but the workstation still cannot reach other subnets. The appropriate action is: Validate the configured default gateway and routing table.
Incorrect Answers
A:Application proxy settings cannot choose the proper subnet lease source. It remains inappropriate in the revised context.
B:VLAN and DHCP diagnostics confirm the client gets an address from the correct scope. The current requirement is: A correct address is assigned but the workstation still cannot reach other subnets.
C:This is the original control. A wrong VLAN or relay can direct clients to unintended addressing services. It does not directly satisfy the revised requirement: A correct address is assigned but the workstation still cannot reach other subnets.
Question 689
Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes. Which action MOST directly meets the stated networking requirement?
- Correct the subnet mask and validate routing through the default gateway.
- Assign unique addresses and enforce DHCP reservations or IPAM governance.
- Add a DNS alias for both printers and leave their duplicate IP unchanged.
- Set a default gateway valid for the new connected prefix.
Explanation
Correct Answer
B:Duplicate IP addresses create inconsistent neighbor resolution and service reachability. This specifically resolves: Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes.
Incorrect Answers
A:This addresses another problem in objective 5.3: A server's subnet mask is accidentally set to /16 rather than /24 and it ARPs for remote hosts that should be routed.
C:Name aliases cannot make identical IPv4 host identities unambiguous. The suggested approach is: Add a DNS alias for both printers and leave their duplicate IP unchanged.
D:This action responds to a later condition: A printer later moves to a different subnet and still uses the old gateway. Subnet migration requires a new on-link gateway and appropriate mask.
Question 690
Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes. A colleague instead suggests: Add a DNS alias for both printers and leave their duplicate IP unchanged. Which finding MOST specifically explains why that suggestion is unsuitable?
- Name aliases cannot make identical IPv4 host identities unambiguous.
- Duplicate IP addresses create inconsistent neighbor resolution and service reachability.
- Subnet migration requires a new on-link gateway and appropriate mask.
- Transport retries cannot fix a false on-link addressing calculation.
Explanation
Correct Answer
A:Name aliases cannot make identical IPv4 host identities unambiguous. This flaw directly concerns the proposed action: Add a DNS alias for both printers and leave their duplicate IP unchanged.
Incorrect Answers
B:This explains why the recommended control works: Assign unique addresses and enforce DHCP reservations or IPAM governance.
C:This rationale belongs to a later changed condition: A printer later moves to a different subnet and still uses the old gateway.
D:This flaw concerns a different case in objective 5.3: A server's subnet mask is accidentally set to /16 rather than /24 and it ARPs for remote hosts that should be routed. The current rejected proposal is: Add a DNS alias for both printers and leave their duplicate IP unchanged.