cert
cert-1
cert-2

Pass CompTIA N10-009 Exam in First Attempt Guaranteed!

Get 100% Latest Exam Questions, Accurate & Verified Answers to Pass the Actual Exam!
30 Days Free Updates, Instant Download!

cert-5
cert-6
N10-009 Exam - Verified By Experts
N10-009 Premium Bundle
$29.98

N10-009 Premium Bundle

$79.99
$109.97
  • Premium File 768 Questions & Answers. Last update: Nov 13, 2026
  • Training Course 240 Video Lectures
  • Study Guide 128 Pages
 
$109.97
$79.99
accept 176 downloads in last 7 days
block-screenshots
Purchase CompTIA N10-009 Exam Training Products Individually
CompTIA N10-009 Premium File
Premium File 768 Q&A
$76.99$69.99
CompTIA N10-009 Video Training Course
Training Course 240 Lectures
$21.99 $19.99
CompTIA N10-009 PDF Study Guide
Study Guide 128 Pages
$21.99 $19.99
CompTIA N10-009 Practice Test 65

Question 640

The original case was: A network engineer must choose whether to test a suspected access-switch issue from physical layer upward or application layer downward. The requirement then changes: A clean IP reachability test rules out lower-layer failure for a specific application. Which revised action BEST meets this new condition?

  1. Choose a random setting to change before defining the fault domain.
  2. Use a structured OSI troubleshooting approach based on observed symptom scope.
  3. Layer-specific tests narrow the failure to the correct interface or protocol.
  4. Move upward to transport sessions and application behavior.

Explanation

Correct Answer

D:

A narrowed layer boundary makes subsequent tests more efficient. The revised requirement is: A clean IP reachability test rules out lower-layer failure for a specific application. The appropriate action is: Move upward to transport sessions and application behavior.

Incorrect Answers

A:

Random edits reduce diagnostic confidence and increase risk. It remains inappropriate in the revised context.

B:

This is the original control. Top-down, bottom-up and divide-and-conquer are structured alternatives chosen by evidence. It does not directly satisfy the revised requirement: A clean IP reachability test rules out lower-layer failure for a specific application.

C:

Layer-specific tests narrow the failure to the correct interface or protocol. The current requirement is: A clean IP reachability test rules out lower-layer failure for a specific application.

Question 641

A technician finds a suspected external routing fault but lacks authority or visibility to test provider routers. Which action MOST directly meets the stated networking requirement?

  1. Follow local change management to test and repair the switching problem.
  2. Escalate the documented findings and observed evidence to the authorized provider team.
  3. Make unauthorized changes to a carrier's equipment to prove the theory.
  4. Interview users and compare local and external test results before choosing a probable cause.

Explanation

Correct Answer

B:

Escalation is appropriate when the probable cause lies beyond local control. This specifically resolves: A technician finds a suspected external routing fault but lacks authority or visibility to test provider routers.

Incorrect Answers

A:

This action responds to a later condition: The same symptom is proven to originate in a local switch under the team's control. A verified local cause should be handled through the responsible internal team.

C:

Access boundaries must be respected during diagnosis. The suggested approach is: Make unauthorized changes to a carrier's equipment to prove the theory.

D:

This addresses another problem in objective 5.1: A user says Wi-Fi is slow but the service desk immediately blames the internet provider.

Question 642

A technician finds a suspected external routing fault but lacks authority or visibility to test provider routers. A colleague instead suggests: Make unauthorized changes to a carrier's equipment to prove the theory. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. Unverified provider blame ignores radio, endpoint and LAN causes.
  2. Escalation is appropriate when the probable cause lies beyond local control.
  3. Access boundaries must be respected during diagnosis.
  4. A verified local cause should be handled through the responsible internal team.

Explanation

Correct Answer

C:

Access boundaries must be respected during diagnosis. This flaw directly concerns the proposed action: Make unauthorized changes to a carrier's equipment to prove the theory.

Incorrect Answers

A:

This flaw concerns a different case in objective 5.1: A user says Wi-Fi is slow but the service desk immediately blames the internet provider. The current rejected proposal is: Make unauthorized changes to a carrier's equipment to prove the theory.

B:

This explains why the recommended control works: Escalate the documented findings and observed evidence to the authorized provider team.

D:

This rationale belongs to a later changed condition: The same symptom is proven to originate in a local switch under the team's control.

Question 643

A technician finds a suspected external routing fault but lacks authority or visibility to test provider routers. After applying the solution 'Escalate the documented findings and observed evidence to the authorized provider team.', which observation MOST directly proves that the requirement was met?

  1. Recorded signal, latency and path tests establish which segment first fails.
  2. The provider confirms the failure from the supplied traces and restores connectivity.
  3. Both ends display conflicting duplex settings and counters match the expected failure.
  4. Approval is recorded for 'Escalate the documented findings and observed evidence to the authorized provider team.' but no operational validation is performed.

Explanation

Correct Answer

B:

The provider confirms the failure from the supplied traces and restores connectivity. It tests the intended outcome because escalation is appropriate when the probable cause lies beyond local control.

Incorrect Answers

A:

This observation is for a different condition: A user says Wi-Fi is slow but the service desk immediately blames the internet provider. It does not directly test the target outcome: A technician finds a suspected external routing fault but lacks authority or visibility to test provider routers.

C:

This test addresses a separate problem: A troubleshooting hypothesis predicts that a duplex mismatch is responsible for a link's errors.

D:

The missing direct test is: The provider confirms the failure from the supplied traces and restores connectivity.

Question 644

The original case was: A technician finds a suspected external routing fault but lacks authority or visibility to test provider routers. The requirement then changes: The same symptom is proven to originate in a local switch under the team's control. Which revised action BEST meets this new condition?

  1. Follow local change management to test and repair the switching problem.
  2. Escalate the documented findings and observed evidence to the authorized provider team.
  3. The provider confirms the failure from the supplied traces and restores connectivity.
  4. Make unauthorized changes to a carrier's equipment to prove the theory.

Explanation

Correct Answer

A:

A verified local cause should be handled through the responsible internal team. The revised requirement is: The same symptom is proven to originate in a local switch under the team's control. The appropriate action is: Follow local change management to test and repair the switching problem.

Incorrect Answers

B:

This is the original control. Escalation is appropriate when the probable cause lies beyond local control. It does not directly satisfy the revised requirement: The same symptom is proven to originate in a local switch under the team's control.

C:

The provider confirms the failure from the supplied traces and restores connectivity. The current requirement is: The same symptom is proven to originate in a local switch under the team's control.

D:

Access boundaries must be respected during diagnosis. It remains inappropriate in the revised context.

Question 645

A new copper patch cable links at 100 Mbps even though both endpoints support gigabit and another cable works. Which action MOST directly meets the stated networking requirement?

  1. Verify polarity and cross-connect the transmit and receive paths correctly.
  2. Raise the router DNS cache timeout to force 1G link negotiation.
  3. Shorten the segment or use an appropriate fiber or active extension.
  4. Test the cable pinout and pair continuity and replace defective termination.

Explanation

Correct Answer

D:

Gigabit copper requires suitable connected pairs and proper cabling. This specifically resolves: A new copper patch cable links at 100 Mbps even though both endpoints support gigabit and another cable works.

Incorrect Answers

A:

This addresses another problem in objective 5.2: A newly installed fiber pair has no link because transmit and receive strands are reversed at one patch panel.

B:

DNS cache settings do not alter twisted-pair signal integrity. The suggested approach is: Raise the router DNS cache timeout to force 1G link negotiation.

C:

This action responds to a later condition: The run is discovered to exceed the supported horizontal cable distance. Length and attenuation limits require changing the physical installation.

Question 646

A new copper patch cable links at 100 Mbps even though both endpoints support gigabit and another cable works. A colleague instead suggests: Raise the router DNS cache timeout to force 1G link negotiation. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. Layer-2 VLAN configuration does not correct physical fiber polarity.
  2. DNS cache settings do not alter twisted-pair signal integrity.
  3. Gigabit copper requires suitable connected pairs and proper cabling.
  4. Length and attenuation limits require changing the physical installation.

Explanation

Correct Answer

B:

DNS cache settings do not alter twisted-pair signal integrity. This flaw directly concerns the proposed action: Raise the router DNS cache timeout to force 1G link negotiation.

Incorrect Answers

A:

This flaw concerns a different case in objective 5.2: A newly installed fiber pair has no link because transmit and receive strands are reversed at one patch panel. The current rejected proposal is: Raise the router DNS cache timeout to force 1G link negotiation.

C:

This explains why the recommended control works: Test the cable pinout and pair continuity and replace defective termination.

D:

This rationale belongs to a later changed condition: The run is discovered to exceed the supported horizontal cable distance.

Question 647

A new copper patch cable links at 100 Mbps even though both endpoints support gigabit and another cable works. After applying the solution 'Test the cable pinout and pair continuity and replace defective termination.', which observation MOST directly proves that the requirement was met?

  1. Optical light measurements and link status become healthy after polarity correction.
  2. Error rates fall when the cable is rerouted or protected from the noise source.
  3. A certified replacement supports gigabit with clean error counters.
  4. Approval is recorded for 'Test the cable pinout and pair continuity and replace defective termination.' but no operational validation is performed.

Explanation

Correct Answer

C:

A certified replacement supports gigabit with clean error counters. It tests the intended outcome because gigabit copper requires suitable connected pairs and proper cabling.

Incorrect Answers

A:

This observation is for a different condition: A newly installed fiber pair has no link because transmit and receive strands are reversed at one patch panel. It does not directly test the target outcome: A new copper patch cable links at 100 Mbps even though both endpoints support gigabit and another cable works.

B:

This test addresses a separate problem: An Ethernet link shows rising CRC errors only when nearby industrial motors run.

D:

Approval alone does not demonstrate operating effectiveness. The missing direct test is: A certified replacement supports gigabit with clean error counters.

Question 648

The original case was: A new copper patch cable links at 100 Mbps even though both endpoints support gigabit and another cable works. The requirement then changes: The run is discovered to exceed the supported horizontal cable distance. Which revised action BEST meets this new condition?

  1. Raise the router DNS cache timeout to force 1G link negotiation.
  2. Test the cable pinout and pair continuity and replace defective termination.
  3. A certified replacement supports gigabit with clean error counters.
  4. Shorten the segment or use an appropriate fiber or active extension.

Explanation

Correct Answer

D:

Length and attenuation limits require changing the physical installation. The revised requirement is: The run is discovered to exceed the supported horizontal cable distance. The appropriate action is: Shorten the segment or use an appropriate fiber or active extension.

Incorrect Answers

A:

DNS cache settings do not alter twisted-pair signal integrity. It remains inappropriate in the revised context.

B:

This is the original control. Gigabit copper requires suitable connected pairs and proper cabling. It does not directly satisfy the revised requirement: The run is discovered to exceed the supported horizontal cable distance.

C:

A certified replacement supports gigabit with clean error counters. The current requirement is: The run is discovered to exceed the supported horizontal cable distance.

Question 649

A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type. Which action MOST directly meets the stated networking requirement?

  1. Reset DHCP leases to repair an incompatible optical wavelength.
  2. Inspect and clean connector ferrules and retest optical loss.
  3. Match optical module specification, wavelength and fiber class at both ends.
  4. Investigate electromagnetic interference and replace or reroute affected cable with suitable shielding.

Explanation

Correct Answer

C:

Optic and fiber mismatch can exceed loss budgets or use incompatible standards. This specifically resolves: A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type.

Incorrect Answers

A:

Address leases cannot fix an absent optical link. The suggested approach is: Reset DHCP leases to repair an incompatible optical wavelength.

B:

This action responds to a later condition: Link comes up but optical errors remain high from dirty connectors. Contamination can degrade an otherwise compatible optical link.

D:

This addresses another problem in objective 5.2: An Ethernet link shows rising CRC errors only when nearby industrial motors run.

Question 650

A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type. Which TWO entries together specify the appropriate corrective measure AND the strongest direct evidence that it works? (Select TWO.)

  1. Inspect and clean connector ferrules and retest optical loss.
  2. Match optical module specification, wavelength and fiber class at both ends.
  3. Investigate electromagnetic interference and replace or reroute affected cable with suitable shielding.
  4. Reset DHCP leases to repair an incompatible optical wavelength.
  5. Compatible modules establish the intended rate with acceptable receive power.

Explanation

Correct Answers

B:

Correct control. Optic and fiber mismatch can exceed loss budgets or use incompatible standards. It addresses the present requirement: A fiber uplink stays down after technicians install a transceiver rated for the wrong fiber type.

E:

Correct verification. Compatible modules establish the intended rate with acceptable receive power. This demonstrates the outcome expected from: Match optical module specification, wavelength and fiber class at both ends.

Incorrect Answers

A:

This is a response to a different later requirement: Link comes up but optical errors remain high from dirty connectors. Contamination can degrade an otherwise compatible optical link. It is not the original control-and-evidence pair.

C:

This control fits another scenario in objective 5.2: An Ethernet link shows rising CRC errors only when nearby industrial motors run. It does not directly verify or implement the present issue.

D:

Incorrect control. Address leases cannot fix an absent optical link. The inappropriate proposal is: Reset DHCP leases to repair an incompatible optical wavelength.

CompTIA Network+ (N10-009) Practice Tests