CompTIA N10-009 Practice Test 24
Question 230
An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10. A colleague instead suggests: Change only the client's DNS server and leave the switch port in the wrong VLAN. Which finding MOST specifically explains why that suggestion is unsuitable?
- Correct VLAN membership determines the local layer-2 broadcast domain.
- Untagged handling still matters and may create cross-VLAN errors.
- DNS settings cannot alter physical port VLAN assignment.
- Voice/data coexistence needs deliberate access and tagging behavior.
Explanation
Correct Answer
C:DNS settings cannot alter physical port VLAN assignment. This flaw directly concerns the proposed action: Change only the client's DNS server and leave the switch port in the wrong VLAN.
Incorrect Answers
A:This explains why the recommended control works: Assign the access interface to VLAN 30 and verify membership.
B:This flaw concerns a different case in objective 2.2: A trunk between two switches forwards untagged frames into different native VLANs on each side. The current rejected proposal is: Change only the client's DNS server and leave the switch port in the wrong VLAN.
D:This rationale belongs to a later changed condition: The same port will connect an IP phone and downstream workstation.
Question 231
An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10. After applying the solution 'Assign the access interface to VLAN 30 and verify membership.', which observation MOST directly proves that the requirement was met?
- Approval is recorded for 'Assign the access interface to VLAN 30 and verify membership.' but no operational validation is performed.
- Neighbor and interface checks agree on native VLAN and no untagged leakage occurs.
- Topology inspection shows one blocked redundant path and stable MAC learning.
- The MAC table and address allocation show the client in VLAN 30.
Explanation
Correct Answer
D:The MAC table and address allocation show the client in VLAN 30. It tests the intended outcome because correct vlan membership determines the local layer-2 broadcast domain.
Incorrect Answers
A:Approval alone does not demonstrate operating effectiveness. The missing direct test is: The MAC table and address allocation show the client in VLAN 30.
B:This observation is for a different condition: A trunk between two switches forwards untagged frames into different native VLANs on each side. It does not directly test the target outcome: An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10.
C:This test addresses a separate problem: Redundant switching links form a loop and broadcast frames multiply until network performance collapses.
Question 232
The original case was: An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10. The requirement then changes: The same port will connect an IP phone and downstream workstation. Which revised action BEST meets this new condition?
- Assign the access interface to VLAN 30 and verify membership.
- Change only the client's DNS server and leave the switch port in the wrong VLAN.
- Configure a supported voice VLAN with separate data VLAN tagging policy.
- The MAC table and address allocation show the client in VLAN 30.
Explanation
Correct Answer
C:Voice/data coexistence needs deliberate access and tagging behavior. The revised requirement is: The same port will connect an IP phone and downstream workstation. The appropriate action is: Configure a supported voice VLAN with separate data VLAN tagging policy.
Incorrect Answers
A:This is the original control. Correct VLAN membership determines the local layer-2 broadcast domain. It does not directly satisfy the revised requirement: The same port will connect an IP phone and downstream workstation.
B:DNS settings cannot alter physical port VLAN assignment. It remains inappropriate in the revised context.
D:The MAC table and address allocation show the client in VLAN 30. The current requirement is: The same port will connect an IP phone and downstream workstation.
Question 233
Two managed switches must carry VLANs 10, 20 and 40 over one inter-switch fiber link. Which action MOST directly meets the stated networking requirement?
- Configure an 802.1Q trunk with explicitly allowed VLANs and consistent native VLAN rules.
- Reduce the allowed VLAN list and disable unused native access paths.
- Enable correctly configured spanning tree and verify root bridge placement.
- Make the uplink an access port in VLAN 10 and expect every VLAN to cross.
Explanation
Correct Answer
A:A trunk carries tagged VLAN traffic across a shared link. This specifically resolves: Two managed switches must carry VLANs 10, 20 and 40 over one inter-switch fiber link.
Incorrect Answers
B:This action responds to a later condition: A new security requirement bans unused VLANs on the trunk. A least-privilege trunk limits which layer-2 networks traverse the link.
C:This addresses another problem in objective 2.2: Redundant switching links form a loop and broadcast frames multiply until network performance collapses.
D:Access ports ordinarily transmit a single VLAN and cannot carry all specified tags. The suggested approach is: Make the uplink an access port in VLAN 10 and expect every VLAN to cross.
Question 234
Two managed switches must carry VLANs 10, 20 and 40 over one inter-switch fiber link. A colleague instead suggests: Make the uplink an access port in VLAN 10 and expect every VLAN to cross. Which finding MOST specifically explains why that suggestion is unsuitable?
- Access ports ordinarily transmit a single VLAN and cannot carry all specified tags.
- A least-privilege trunk limits which layer-2 networks traverse the link.
- A trunk carries tagged VLAN traffic across a shared link.
- Simultaneous bridging loops amplify broadcasts and cause MAC instability.
Explanation
Correct Answer
A:Access ports ordinarily transmit a single VLAN and cannot carry all specified tags. This flaw directly concerns the proposed action: Make the uplink an access port in VLAN 10 and expect every VLAN to cross.
Incorrect Answers
B:This rationale belongs to a later changed condition: A new security requirement bans unused VLANs on the trunk.
C:This explains why the recommended control works: Configure an 802.1Q trunk with explicitly allowed VLANs and consistent native VLAN rules.
D:This flaw concerns a different case in objective 2.2: Redundant switching links form a loop and broadcast frames multiply until network performance collapses. The current rejected proposal is: Make the uplink an access port in VLAN 10 and expect every VLAN to cross.
Question 235
Two managed switches must carry VLANs 10, 20 and 40 over one inter-switch fiber link. After applying the solution 'Configure an 802.1Q trunk with explicitly allowed VLANs and consistent native VLAN rules.', which observation MOST directly proves that the requirement was met?
- Both sides report the allowed trunk VLANs and clients communicate only in intended segments.
- Approval is recorded for 'Configure an 802.1Q trunk with explicitly allowed VLANs and consistent native VLAN rules.' but no operational validation is performed.
- Port-channel status shows all intended members active and a failed member does not isolate the service.
- Topology inspection shows one blocked redundant path and stable MAC learning.
Explanation
Correct Answer
A:Both sides report the allowed trunk VLANs and clients communicate only in intended segments. It tests the intended outcome because a trunk carries tagged vlan traffic across a shared link.
Incorrect Answers
B:The missing direct test is: Both sides report the allowed trunk VLANs and clients communicate only in intended segments.
C:This test addresses a separate problem: A team wants two same-speed switch uplinks to operate as one logical connection without creating a loop.
D:This observation is for a different condition: Redundant switching links form a loop and broadcast frames multiply until network performance collapses. It does not directly test the target outcome: Two managed switches must carry VLANs 10, 20 and 40 over one inter-switch fiber link.
Question 236
The original case was: Two managed switches must carry VLANs 10, 20 and 40 over one inter-switch fiber link. The requirement then changes: A new security requirement bans unused VLANs on the trunk. Which revised action BEST meets this new condition?
- Configure an 802.1Q trunk with explicitly allowed VLANs and consistent native VLAN rules.
- Both sides report the allowed trunk VLANs and clients communicate only in intended segments.
- Reduce the allowed VLAN list and disable unused native access paths.
- Make the uplink an access port in VLAN 10 and expect every VLAN to cross.
Explanation
Correct Answer
C:A least-privilege trunk limits which layer-2 networks traverse the link. The revised requirement is: A new security requirement bans unused VLANs on the trunk. The appropriate action is: Reduce the allowed VLAN list and disable unused native access paths.
Incorrect Answers
A:This is the original control. A trunk carries tagged VLAN traffic across a shared link. It does not directly satisfy the revised requirement: A new security requirement bans unused VLANs on the trunk.
B:Both sides report the allowed trunk VLANs and clients communicate only in intended segments. The current requirement is: A new security requirement bans unused VLANs on the trunk.
D:Access ports ordinarily transmit a single VLAN and cannot carry all specified tags. It remains inappropriate in the revised context.
Question 237
A trunk between two switches forwards untagged frames into different native VLANs on each side. Which action MOST directly meets the stated networking requirement?
- Ignore the mismatch because tagged traffic exists elsewhere.
- Use a dedicated unused native VLAN or fully tagged configuration where supported.
- Align supported native VLAN configuration or tag native traffic consistently.
- Configure a compatible LACP port channel at both ends.
Explanation
Correct Answer
C:Mismatched native VLANs can leak or misdirect untagged traffic across boundaries. This specifically resolves: A trunk between two switches forwards untagged frames into different native VLANs on each side.
Incorrect Answers
A:Untagged handling still matters and may create cross-VLAN errors. The suggested approach is: Ignore the mismatch because tagged traffic exists elsewhere.
B:This action responds to a later condition: The organization wants no untagged production user traffic at all. Separating or tagging native traffic reduces accidental VLAN crossover.
D:This addresses another problem in objective 2.2: A team wants two same-speed switch uplinks to operate as one logical connection without creating a loop.
Question 238
A trunk between two switches forwards untagged frames into different native VLANs on each side. A colleague instead suggests: Ignore the mismatch because tagged traffic exists elsewhere. Which finding MOST specifically explains why that suggestion is unsuitable?
- Untagged handling still matters and may create cross-VLAN errors.
- Separating or tagging native traffic reduces accidental VLAN crossover.
- Mismatched native VLANs can leak or misdirect untagged traffic across boundaries.
- Incompatible member settings may suspend or disrupt aggregation.
Explanation
Correct Answer
A:Untagged handling still matters and may create cross-VLAN errors. This flaw directly concerns the proposed action: Ignore the mismatch because tagged traffic exists elsewhere.
Incorrect Answers
B:This rationale belongs to a later changed condition: The organization wants no untagged production user traffic at all.
C:This explains why the recommended control works: Align supported native VLAN configuration or tag native traffic consistently.
D:This flaw concerns a different case in objective 2.2: A team wants two same-speed switch uplinks to operate as one logical connection without creating a loop. The current rejected proposal is: Ignore the mismatch because tagged traffic exists elsewhere.
Question 239
A trunk between two switches forwards untagged frames into different native VLANs on each side. After applying the solution 'Align supported native VLAN configuration or tag native traffic consistently.', which observation MOST directly proves that the requirement was met?
- Clients ARP for the SVI and reach an authorized remote subnet.
- Port-channel status shows all intended members active and a failed member does not isolate the service.
- Neighbor and interface checks agree on native VLAN and no untagged leakage occurs.
- Approval is recorded for 'Align supported native VLAN configuration or tag native traffic consistently.' but no operational validation is performed.
Explanation
Correct Answer
C:Neighbor and interface checks agree on native VLAN and no untagged leakage occurs. It tests the intended outcome because mismatched native vlans can leak or misdirect untagged traffic across boundaries.
Incorrect Answers
A:This test addresses a separate problem: Servers in VLAN 70 need an IP default gateway hosted directly on a multilayer switch.
B:This observation is for a different condition: A team wants two same-speed switch uplinks to operate as one logical connection without creating a loop. It does not directly test the target outcome: A trunk between two switches forwards untagged frames into different native VLANs on each side.
D:The missing direct test is: Neighbor and interface checks agree on native VLAN and no untagged leakage occurs.
Question 240
The original case was: A trunk between two switches forwards untagged frames into different native VLANs on each side. The requirement then changes: The organization wants no untagged production user traffic at all. Which revised action BEST meets this new condition?
- Align supported native VLAN configuration or tag native traffic consistently.
- Neighbor and interface checks agree on native VLAN and no untagged leakage occurs.
- Ignore the mismatch because tagged traffic exists elsewhere.
- Use a dedicated unused native VLAN or fully tagged configuration where supported.
Explanation
Correct Answer
D:Separating or tagging native traffic reduces accidental VLAN crossover. The revised requirement is: The organization wants no untagged production user traffic at all. The appropriate action is: Use a dedicated unused native VLAN or fully tagged configuration where supported.
Incorrect Answers
A:This is the original control. Mismatched native VLANs can leak or misdirect untagged traffic across boundaries. It does not directly satisfy the revised requirement: The organization wants no untagged production user traffic at all.
B:Neighbor and interface checks agree on native VLAN and no untagged leakage occurs. The current requirement is: The organization wants no untagged production user traffic at all.
C:Untagged handling still matters and may create cross-VLAN errors. It remains inappropriate in the revised context.