CompTIA N10-009 Practice Test 23
Question 220
The original case was: One physical uplink carries traffic for three routed VLANs to a router with no separate physical ports. The requirement then changes: The router is replaced by a capable multilayer switch for local inter-VLAN routing. Which revised action BEST meets this new condition?
- Use switched virtual interfaces and appropriate Layer 3 routing on the switch.
- Each VLAN reaches its own subinterface gateway while inter-VLAN policy is enforced.
- Assign all VLANs the same layer-3 IP gateway without distinct subinterfaces.
- Use 802.1Q-tagged router subinterfaces with unique IP gateways per VLAN.
Explanation
Correct Answer
A:SVIs provide routed gateways on a multilayer switching platform. The revised requirement is: The router is replaced by a capable multilayer switch for local inter-VLAN routing. The appropriate action is: Use switched virtual interfaces and appropriate Layer 3 routing on the switch.
Incorrect Answers
B:Each VLAN reaches its own subinterface gateway while inter-VLAN policy is enforced. The current requirement is: The router is replaced by a capable multilayer switch for local inter-VLAN routing.
C:Shared addressing prevents correct routing and segmentation per VLAN. It remains inappropriate in the revised context.
D:This is the original control. Logical subinterfaces provide routed interfaces over a shared tagged physical trunk. It does not directly satisfy the revised requirement: The router is replaced by a capable multilayer switch for local inter-VLAN routing.
Question 221
The routing team must prevent a less-trusted learned default route from overriding a known corporate route. Which action MOST directly meets the stated networking requirement?
- Accept every default route advertisement from any directly connected device.
- Configure a static route for the correct destination prefix and reachable next hop.
- Use health-aware path selection with monitored metrics or SD-WAN as appropriate.
- Filter the learned route and enforce approved route-source preference or policy.
Explanation
Correct Answer
D:Explicit route policy prevents accidental insertion of an unsafe forwarding path. This specifically resolves: The routing team must prevent a less-trusted learned default route from overriding a known corporate route.
Incorrect Answers
A:Uncontrolled route acceptance can redirect traffic or create black holes. The suggested approach is: Accept every default route advertisement from any directly connected device.
B:This addresses another problem in objective 2.1: A branch router needs a single route to a specific remote subnet through a stable leased-line neighbor.
C:This action responds to a later condition: The routing policy must now dynamically select lower-latency paths for applications. Latency-aware steering needs current path measurements beyond static advertisement filters.
Question 222
The routing team must prevent a less-trusted learned default route from overriding a known corporate route. A colleague instead suggests: Accept every default route advertisement from any directly connected device. Which finding MOST specifically explains why that suggestion is unsuitable?
- Explicit route policy prevents accidental insertion of an unsafe forwarding path.
- Latency-aware steering needs current path measurements beyond static advertisement filters.
- A broad default route may misdirect other traffic and does not validate the intended prefix.
- Uncontrolled route acceptance can redirect traffic or create black holes.
Explanation
Correct Answer
D:Uncontrolled route acceptance can redirect traffic or create black holes. This flaw directly concerns the proposed action: Accept every default route advertisement from any directly connected device.
Incorrect Answers
A:This explains why the recommended control works: Filter the learned route and enforce approved route-source preference or policy.
B:This rationale belongs to a later changed condition: The routing policy must now dynamically select lower-latency paths for applications.
C:This flaw concerns a different case in objective 2.1: A branch router needs a single route to a specific remote subnet through a stable leased-line neighbor. The current rejected proposal is: Accept every default route advertisement from any directly connected device.
Question 223
The routing team must prevent a less-trusted learned default route from overriding a known corporate route. After applying the solution 'Filter the learned route and enforce approved route-source preference or policy.', which observation MOST directly proves that the requirement was met?
- The routing table selects the static route and traffic reaches the remote prefix.
- Route-table inspection shows only authorized next-hop candidates installed.
- Loss of one link triggers neighbor events and a converged alternate OSPF route.
- Approval is recorded for 'Filter the learned route and enforce approved route-source preference or policy.' but no operational validation is performed.
Explanation
Correct Answer
B:Route-table inspection shows only authorized next-hop candidates installed. It tests the intended outcome because explicit route policy prevents accidental insertion of an unsafe forwarding path.
Incorrect Answers
A:This observation is for a different condition: A branch router needs a single route to a specific remote subnet through a stable leased-line neighbor. It does not directly test the target outcome: The routing team must prevent a less-trusted learned default route from overriding a known corporate route.
C:This test addresses a separate problem: An internal campus needs automatic route learning and shortest-path recalculation after router failure.
D:The missing direct test is: Route-table inspection shows only authorized next-hop candidates installed.
Question 224
The original case was: The routing team must prevent a less-trusted learned default route from overriding a known corporate route. The requirement then changes: The routing policy must now dynamically select lower-latency paths for applications. Which revised action BEST meets this new condition?
- Route-table inspection shows only authorized next-hop candidates installed.
- Accept every default route advertisement from any directly connected device.
- Filter the learned route and enforce approved route-source preference or policy.
- Use health-aware path selection with monitored metrics or SD-WAN as appropriate.
Explanation
Correct Answer
D:Latency-aware steering needs current path measurements beyond static advertisement filters. The revised requirement is: The routing policy must now dynamically select lower-latency paths for applications. The appropriate action is: Use health-aware path selection with monitored metrics or SD-WAN as appropriate.
Incorrect Answers
A:Route-table inspection shows only authorized next-hop candidates installed. The current requirement is: The routing policy must now dynamically select lower-latency paths for applications.
B:Uncontrolled route acceptance can redirect traffic or create black holes. It remains inappropriate in the revised context.
C:This is the original control. Explicit route policy prevents accidental insertion of an unsafe forwarding path. It does not directly satisfy the revised requirement: The routing policy must now dynamically select lower-latency paths for applications.
Question 225
A campus uses EIGRP internally and wants to ensure neighbors agree on autonomous-system and authentication settings. Which TWO entries together specify the appropriate corrective measure AND the strongest direct evidence that it works? (Select TWO.)
- Plan a controlled route-protocol migration with tested OSPF adjacencies.
- Expect an OSPF neighbor command to establish an EIGRP adjacency.
- Match supported EIGRP adjacency parameters and authenticate routing exchanges.
- Use OSPF with verified adjacencies, areas and routing advertisements.
- Neighbor status and learned routes show authenticated adjacency and intended reachability.
Explanation
Correct Answers
C:Correct control. Routing neighbors must agree on protocol and relevant policy to form adjacency. It addresses the present requirement: A campus uses EIGRP internally and wants to ensure neighbors agree on autonomous-system and authentication settings.
E:Correct verification. Neighbor status and learned routes show authenticated adjacency and intended reachability. This demonstrates the outcome expected from: Match supported EIGRP adjacency parameters and authenticate routing exchanges.
Incorrect Answers
A:This is a response to a different later requirement: The campus migrates to a multivendor environment that standardizes on OSPF. Protocol migration requires interoperability and coordinated transition controls. It is not the original control-and-evidence pair.
B:Incorrect control. Different routing protocols do not inherently exchange neighbor state. The inappropriate proposal is: Expect an OSPF neighbor command to establish an EIGRP adjacency.
D:This control fits another scenario in objective 2.1: An internal campus needs automatic route learning and shortest-path recalculation after router failure. It does not directly verify or implement the present issue.
Question 226
A campus uses EIGRP internally and wants to ensure neighbors agree on autonomous-system and authentication settings. A colleague instead suggests: Expect an OSPF neighbor command to establish an EIGRP adjacency. Which finding MOST specifically explains why that suggestion is unsuitable?
- Protocol migration requires interoperability and coordinated transition controls.
- DNS aliases do not exchange layer-3 routes.
- Different routing protocols do not inherently exchange neighbor state.
- Routing neighbors must agree on protocol and relevant policy to form adjacency.
Explanation
Correct Answer
C:Different routing protocols do not inherently exchange neighbor state. This flaw directly concerns the proposed action: Expect an OSPF neighbor command to establish an EIGRP adjacency.
Incorrect Answers
A:This rationale belongs to a later changed condition: The campus migrates to a multivendor environment that standardizes on OSPF.
B:This flaw concerns a different case in objective 2.1: An internal campus needs automatic route learning and shortest-path recalculation after router failure. The current rejected proposal is: Expect an OSPF neighbor command to establish an EIGRP adjacency.
D:This explains why the recommended control works: Match supported EIGRP adjacency parameters and authenticate routing exchanges.
Question 227
A campus uses EIGRP internally and wants to ensure neighbors agree on autonomous-system and authentication settings. After applying the solution 'Match supported EIGRP adjacency parameters and authenticate routing exchanges.', which observation MOST directly proves that the requirement was met?
- Peer sessions establish and received or advertised BGP routes match policy.
- Approval is recorded for 'Match supported EIGRP adjacency parameters and authenticate routing exchanges.' but no operational validation is performed.
- Neighbor status and learned routes show authenticated adjacency and intended reachability.
- Loss of one link triggers neighbor events and a converged alternate OSPF route.
Explanation
Correct Answer
C:Neighbor status and learned routes show authenticated adjacency and intended reachability. It tests the intended outcome because routing neighbors must agree on protocol and relevant policy to form adjacency.
Incorrect Answers
A:This test addresses a separate problem: A multihomed organization needs routing policies for prefixes advertised by two upstream internet providers.
B:The missing direct test is: Neighbor status and learned routes show authenticated adjacency and intended reachability.
D:This observation is for a different condition: An internal campus needs automatic route learning and shortest-path recalculation after router failure. It does not directly test the target outcome: A campus uses EIGRP internally and wants to ensure neighbors agree on autonomous-system and authentication settings.
Question 228
The original case was: A campus uses EIGRP internally and wants to ensure neighbors agree on autonomous-system and authentication settings. The requirement then changes: The campus migrates to a multivendor environment that standardizes on OSPF. Which revised action BEST meets this new condition?
- Neighbor status and learned routes show authenticated adjacency and intended reachability.
- Expect an OSPF neighbor command to establish an EIGRP adjacency.
- Plan a controlled route-protocol migration with tested OSPF adjacencies.
- Match supported EIGRP adjacency parameters and authenticate routing exchanges.
Explanation
Correct Answer
C:Protocol migration requires interoperability and coordinated transition controls. The revised requirement is: The campus migrates to a multivendor environment that standardizes on OSPF. The appropriate action is: Plan a controlled route-protocol migration with tested OSPF adjacencies.
Incorrect Answers
A:Neighbor status and learned routes show authenticated adjacency and intended reachability. The current requirement is: The campus migrates to a multivendor environment that standardizes on OSPF.
B:Different routing protocols do not inherently exchange neighbor state. It remains inappropriate in the revised context.
D:This is the original control. Routing neighbors must agree on protocol and relevant policy to form adjacency. It does not directly satisfy the revised requirement: The campus migrates to a multivendor environment that standardizes on OSPF.
Question 229
An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10. Which action MOST directly meets the stated networking requirement?
- Change only the client's DNS server and leave the switch port in the wrong VLAN.
- Assign the access interface to VLAN 30 and verify membership.
- Align supported native VLAN configuration or tag native traffic consistently.
- Configure a supported voice VLAN with separate data VLAN tagging policy.
Explanation
Correct Answer
B:Correct VLAN membership determines the local layer-2 broadcast domain. This specifically resolves: An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10.
Incorrect Answers
A:DNS settings cannot alter physical port VLAN assignment. The suggested approach is: Change only the client's DNS server and leave the switch port in the wrong VLAN.
C:This addresses another problem in objective 2.2: A trunk between two switches forwards untagged frames into different native VLANs on each side.
D:This action responds to a later condition: The same port will connect an IP phone and downstream workstation. Voice/data coexistence needs deliberate access and tagging behavior.
Question 230
An employee port belongs in VLAN 30 but the switch currently places it in VLAN 10. A colleague instead suggests: Change only the client's DNS server and leave the switch port in the wrong VLAN. Which finding MOST specifically explains why that suggestion is unsuitable?
- Correct VLAN membership determines the local layer-2 broadcast domain.
- Untagged handling still matters and may create cross-VLAN errors.
- DNS settings cannot alter physical port VLAN assignment.
- Voice/data coexistence needs deliberate access and tagging behavior.
Explanation
Correct Answer
C:DNS settings cannot alter physical port VLAN assignment. This flaw directly concerns the proposed action: Change only the client's DNS server and leave the switch port in the wrong VLAN.
Incorrect Answers
A:This explains why the recommended control works: Assign the access interface to VLAN 30 and verify membership.
B:This flaw concerns a different case in objective 2.2: A trunk between two switches forwards untagged frames into different native VLANs on each side. The current rejected proposal is: Change only the client's DNS server and leave the switch port in the wrong VLAN.
D:This rationale belongs to a later changed condition: The same port will connect an IP phone and downstream workstation.