Cisco 300-420 Practice Test 26
Question 250
A routed distribution core needs quick path failure detection without drastically reducing all protocol hello timers. The observed fault is: Overly aggressive BFD timers can trigger flaps or load devices beyond their control-plane capacity. What action most directly restores and validates the intended state?
- The controlled recovery is to expect Ethernet carrier up to guarantee the routed neighbor remains usable.
- The controlled recovery is to assume BFD sessions automatically replace all routing protocol path selection.
- The controlled recovery is to configure the minimum possible timers without checking hardware and topology stability.
- The controlled recovery is to set supported timers and validate both real outage detection and false-positive rates.
Explanation
Correct Answer
D:Relevant evidence includes bFD session state, routing adjacency dependencies, failure detection latency and CPU capacity. This corrects the described failure and provides a verifiable outcome.
Incorrect Answers
A:Expect Ethernet carrier up to guarantee the routed neighbor remains usable. Overly aggressive BFD timers can trigger flaps or load devices beyond their control-plane capacity. Use the controlled remediation: set supported timers and validate both real outage detection and false-positive rates.
B:Assume BFD sessions automatically replace all routing protocol path selection. Overly aggressive BFD timers can trigger flaps or load devices beyond their control-plane capacity. Use the controlled remediation: set supported timers and validate both real outage detection and false-positive rates.
C:Configure the minimum possible timers without checking hardware and topology stability. Overly aggressive BFD timers can trigger flaps or load devices beyond their control-plane capacity. Use the controlled remediation: set supported timers and validate both real outage detection and false-positive rates.
Question 251
An access VLAN elects an unintended remote low-capacity switch as STP root causing suboptimal traffic paths. What is the most defensible configuration decision?
- Set deliberate primary and secondary STP root placement at resilient distribution devices.
- Leave every switch at an identical default priority and assume the desired root always wins.
- Disable STP globally to avoid root election complexity.
- Use only OSPF cost changes to choose the Layer 2 spanning-tree root.
Explanation
Correct Answer
A:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. This is the specific corrective action for Campus STP root bridge placement.
Incorrect Answers
B:Allowing an access switch to become root can send traffic across inefficient or fragile paths. This change targets the wrong mechanism for Campus STP root bridge placement.
C:Disable STP globally to avoid root election complexity. STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Instead inspect bridge priorities, root path cost, blocked ports and convergence on failure.
D:Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use only OSPF cost changes to choose the Layer 2 spanning-tree root.
Question 252
An access VLAN elects an unintended remote low-capacity switch as STP root causing suboptimal traffic paths. Which evidence BEST confirms the actual technical behavior?
- An old network diagram with no current route, policy, or redundancy state.
- One successful ping to an unrelated test host without a path or failover test.
- Bridge priorities, root path cost, blocked ports and convergence on failure.
- A marketing claim without measured routing, capacity or failure-domain evidence.
Explanation
Correct Answer
C:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. This evidence observes the actual campus STP root bridge placement mechanism and its result.
Incorrect Answers
A:This observation alone cannot establish campus STP root bridge placement. The decisive evidence instead includes bridge priorities, root path cost, blocked ports and convergence on failure.
B:This observation alone cannot establish campus STP root bridge placement. STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier.
D:This observation alone cannot establish campus STP root bridge placement. A marketing claim without measured routing, capacity or failure-domain evidence.
Question 253
An access VLAN elects an unintended remote low-capacity switch as STP root causing suboptimal traffic paths. What networking or enterprise network design concept best explains this scenario?
- An operational up state alone proves every security and design objective is met.
- Any single device automatically guarantees high availability for every site.
- STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier.
- A longer IP prefix is always less specific than the default route.
Explanation
Correct Answer
C:This is why the appropriate action is set deliberate primary and secondary STP root placement at resilient distribution devices. Confirm it with bridge priorities, root path cost, blocked ports and convergence on failure.
Incorrect Answers
A:An operational up state alone proves every security and design objective is met. This is an incorrect generalization for campus STP root bridge placement. The relevant rule is sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Verify using bridge priorities, root path cost, blocked ports and convergence on failure.
B:Any single device automatically guarantees high availability for every site. This is an incorrect generalization for campus STP root bridge placement. The relevant rule is sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Verify using bridge priorities, root path cost, blocked ports and convergence on failure.
D:A longer IP prefix is always less specific than the default route. This is an incorrect generalization for campus STP root bridge placement. The relevant rule is sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Verify using bridge priorities, root path cost, blocked ports and convergence on failure.
Question 254
An access VLAN elects an unintended remote low-capacity switch as STP root causing suboptimal traffic paths. Suppose the operator instead makes this incorrect change: Leave every switch at an identical default priority and assume the desired root always wins. Which resulting fault should the reviewer identify?
- Allowing an access switch to become root can send traffic across inefficient or fragile paths.
- The failure is entirely cosmetic because all control-plane changes are harmless.
- Collecting telemetry originally caused the missing route or service outage.
- A correct change-control review makes all WAN carriers fail simultaneously.
Explanation
Correct Answer
A:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. This explains why the proposed shortcut does not solve campus STP root bridge placement.
Incorrect Answers
B:The failure is entirely cosmetic because all control-plane changes are harmless. The actual failure is allowing an access switch to become root can send traffic across inefficient or fragile paths. Check bridge priorities, root path cost, blocked ports and convergence on failure.
C:Collecting telemetry originally caused the missing route or service outage. The actual failure is allowing an access switch to become root can send traffic across inefficient or fragile paths. Check bridge priorities, root path cost, blocked ports and convergence on failure.
D:A correct change-control review makes all WAN carriers fail simultaneously. The actual failure is allowing an access switch to become root can send traffic across inefficient or fragile paths. Check bridge priorities, root path cost, blocked ports and convergence on failure.
Question 255
An access VLAN elects an unintended remote low-capacity switch as STP root causing suboptimal traffic paths. The observed fault is: Allowing an access switch to become root can send traffic across inefficient or fragile paths. How should the issue be corrected and verified?
- Adjust bridge priorities and confirm root and backup paths for representative VLANs.
- Disable STP globally to avoid root election complexity.
- Use only OSPF cost changes to choose the Layer 2 spanning-tree root.
- Leave every switch at an identical default priority and assume the desired root always wins.
Explanation
Correct Answer
A:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. This corrects the described failure and provides a verifiable outcome.
Incorrect Answers
B:Disable STP globally to avoid root election complexity. Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use the controlled remediation: adjust bridge priorities and confirm root and backup paths for representative VLANs.
C:Use only OSPF cost changes to choose the Layer 2 spanning-tree root. Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use the controlled remediation: adjust bridge priorities and confirm root and backup paths for representative VLANs.
D:Leave every switch at an identical default priority and assume the desired root always wins. Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use the controlled remediation: adjust bridge priorities and confirm root and backup paths for representative VLANs.
Question 256
A new campus access block is added and root selection becomes nondeterministic under existing default priorities. What is the BEST supported implementation or corrective action?
- For this enterprise design, the architect should disable STP globally to avoid root election complexity.
- For this enterprise design, the architect should use only OSPF cost changes to choose the Layer 2 spanning-tree root.
- For this enterprise design, the architect should leave every switch at an identical default priority and assume the desired root always wins.
- For this enterprise design, the architect should set deliberate primary and secondary STP root placement at resilient distribution devices.
Explanation
Correct Answer
D:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Confirm the result using bridge priorities, root path cost, blocked ports and convergence on failure.
Incorrect Answers
A:Disable STP globally to avoid root election complexity. STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Instead inspect bridge priorities, root path cost, blocked ports and convergence on failure.
B:Allowing an access switch to become root can send traffic across inefficient or fragile paths. In this case, a new campus access block is added and root selection becomes nondeterministic under existing default priorities.
C:Allowing an access switch to become root can send traffic across inefficient or fragile paths. The relevant action is set deliberate primary and secondary STP root placement at resilient distribution devices.
Question 257
A new campus access block is added and root selection becomes nondeterministic under existing default priorities. What should the operator inspect to verify the result?
- Inspect the following evidence: a hostname inventory without effective configuration or operational measurements.
- Inspect the following evidence: an old network diagram with no current route, policy, or redundancy state.
- Inspect the following evidence: one successful ping to an unrelated test host without a path or failover test.
- Inspect the following evidence: bridge priorities, root path cost, blocked ports and convergence on failure.
Explanation
Correct Answer
D:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. The intended procedure is set deliberate primary and secondary STP root placement at resilient distribution devices.
Incorrect Answers
A:This observation alone cannot establish campus STP root bridge placement. A hostname inventory without effective configuration or operational measurements.
B:This observation alone cannot establish campus STP root bridge placement. An old network diagram with no current route, policy, or redundancy state.
C:This observation alone cannot establish campus STP root bridge placement. One successful ping to an unrelated test host without a path or failover test.
Question 258
A new campus access block is added and root selection becomes nondeterministic under existing default priorities. Which technical statement is MOST accurate for this situation?
- The relevant principle is that a longer IP prefix is always less specific than the default route.
- The relevant principle is that an operational up state alone proves every security and design objective is met.
- The relevant principle is that sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier.
- The relevant principle is that encryption and segmentation are identical mechanisms and can replace each other.
Explanation
Correct Answer
C:This is why the appropriate action is set deliberate primary and secondary STP root placement at resilient distribution devices.
Incorrect Answers
A:A longer IP prefix is always less specific than the default route. This is an incorrect generalization for campus STP root bridge placement. The relevant rule is sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Verify using bridge priorities, root path cost, blocked ports and convergence on failure.
B:An operational up state alone proves every security and design objective is met. This is an incorrect generalization for campus STP root bridge placement. The relevant rule is sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Verify using bridge priorities, root path cost, blocked ports and convergence on failure.
D:Encryption and segmentation are identical mechanisms and can replace each other. This is an incorrect generalization for campus STP root bridge placement. The relevant rule is sTP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Verify using bridge priorities, root path cost, blocked ports and convergence on failure.
Question 259
A new campus access block is added and root selection becomes nondeterministic under existing default priorities. Suppose the operator instead makes this incorrect change: Leave every switch at an identical default priority and assume the desired root always wins. What weakness does the mistaken approach introduce?
- The resulting technical fault is that a correct change-control review makes all WAN carriers fail simultaneously.
- The resulting technical fault is that allowing an access switch to become root can send traffic across inefficient or fragile paths.
- The resulting technical fault is that the only issue is an inaccurate hostname while traffic paths are unaffected.
- The resulting technical fault is that collecting telemetry originally caused the missing route or service outage.
Explanation
Correct Answer
B:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. The right response is set deliberate primary and secondary STP root placement at resilient distribution devices.
Incorrect Answers
A:A correct change-control review makes all WAN carriers fail simultaneously. The actual failure is allowing an access switch to become root can send traffic across inefficient or fragile paths. Check bridge priorities, root path cost, blocked ports and convergence on failure.
C:The only issue is an inaccurate hostname while traffic paths are unaffected. The actual failure is allowing an access switch to become root can send traffic across inefficient or fragile paths. Check bridge priorities, root path cost, blocked ports and convergence on failure.
D:Collecting telemetry originally caused the missing route or service outage. The actual failure is allowing an access switch to become root can send traffic across inefficient or fragile paths. Check bridge priorities, root path cost, blocked ports and convergence on failure.
Question 260
A new campus access block is added and root selection becomes nondeterministic under existing default priorities. The observed fault is: Allowing an access switch to become root can send traffic across inefficient or fragile paths. Which recovery is BEST once this fault is identified?
- The controlled recovery is to use only OSPF cost changes to choose the Layer 2 spanning-tree root.
- The controlled recovery is to leave every switch at an identical default priority and assume the desired root always wins.
- The controlled recovery is to disable STP globally to avoid root election complexity.
- The controlled recovery is to adjust bridge priorities and confirm root and backup paths for representative VLANs.
Explanation
Correct Answer
D:STP computes a loop-free logical topology relative to a root bridge selected by bridge identifier. Relevant evidence includes bridge priorities, root path cost, blocked ports and convergence on failure.
Incorrect Answers
A:Use only OSPF cost changes to choose the Layer 2 spanning-tree root. Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use the controlled remediation: adjust bridge priorities and confirm root and backup paths for representative VLANs.
B:Leave every switch at an identical default priority and assume the desired root always wins. Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use the controlled remediation: adjust bridge priorities and confirm root and backup paths for representative VLANs.
C:Disable STP globally to avoid root election complexity. Allowing an access switch to become root can send traffic across inefficient or fragile paths. Use the controlled remediation: adjust bridge priorities and confirm root and backup paths for representative VLANs.