Test Prep ASVAB Test Practice Test 47
Question 460
What do shock absorbers primarily control?
- Suspension oscillation by damping
- Engine coolant pressure
- Spark timing
- Fuel viscosity
Explanation
Correct Answer
A:Best answer. Dampers dissipate bouncing energy. This is the concept directly requested by the question.
Incorrect Answers
B:Not best. Engine coolant pressure: Pressure caps control coolant pressure.
C:Not best. Spark timing: Ignition timing is unrelated. It does not meet the specific requirement in the question.
D:Not best. Fuel viscosity: Fuel composition controls viscosity.
Question 461
What is a tire's tread depth important for?
- Increasing spark voltage
- Traction and water evacuation
- Setting gear ratios
- Charging the battery
Explanation
Correct Answer
B:Best answer. Adequate tread helps grip wet surfaces and resist hydroplaning.
Incorrect Answers
A:Not best. Increasing spark voltage: Tread has no role in ignition.
C:Not best. Setting gear ratios: Transmission gears set ratios.
D:Not best. Charging the battery: Tires do not normally generate charging power.
Question 462
Why should tires be inflated to the specified cold pressure?
- To make brakes unnecessary
- To support intended load, handling, and wear behavior
- To increase coolant flow
- To adjust valve timing
Explanation
Correct Answer
B:Best answer. Correct cold inflation supports safe tire performance.
Incorrect Answers
A:Not best. To make brakes unnecessary: Tire inflation cannot replace brakes.
C:Not best. To increase coolant flow: Tire pressure does not pump coolant.
D:Not best. To adjust valve timing: Cam timing is separate.
Question 463
Which condition most directly describes hydroplaning?
- Tires ride on water and lose road contact
- The alternator stops charging
- Brake fluid turns to vapor
- Engine oil enters the cylinder
Explanation
Correct Answer
A:Best answer. A water film can reduce traction and steering.
Incorrect Answers
B:Not best. The alternator stops charging: Hydroplaning is road/tire interaction.
C:Not best. Brake fluid turns to vapor: That is a brake fade issue.
D:Not best. Engine oil enters the cylinder: That is not tire hydroplaning.
Question 464
What does a tie rod connect in a typical steering linkage?
- Spark plug to coil wire only
- Steering mechanism to steering knuckle
- Radiator to coolant reservoir
- Battery to starter relay only
Explanation
Correct Answer
B:Best answer. Tie rods transmit steering motion to wheels.
Incorrect Answers
A:Not best. Spark plug to coil wire only: That is ignition wiring.
C:Not best. Radiator to coolant reservoir: That is cooling plumbing.
D:Not best. Battery to starter relay only: That is electrical cabling.
Question 465
What is the purpose of an engine oil filter?
- Cool cabin air
- Change transmission ratios
- Remove suspended contaminants from oil
- Raise fuel pressure
Explanation
Correct Answer
C:Best answer. Filters trap particles in circulating lubricant.
Incorrect Answers
A:Not best. Cool cabin air: Cabin systems have separate filters.
B:Not best. Change transmission ratios: Gearsets do that.
D:Not best. Raise fuel pressure: Fuel systems contain pumps/regulators.
Question 466
Which battery-terminal condition may cause difficult starting?
- Fresh coolant mix
- Corrosion causing high contact resistance
- Properly torqued clean contacts
- Correct tire pressure
Explanation
Correct Answer
B:Best answer. Poor electrical connections can limit starter current.
Incorrect Answers
A:Not best. Fresh coolant mix: Coolant is unrelated to terminal resistance.
C:Not best. Properly torqued clean contacts: Clean connections improve current transfer.
D:Not best. Correct tire pressure: Tire inflation does not cause cranking resistance.
Question 467
What does a vehicle's ECU or PCM do?
- Generate all power without fuel
- Control engine or powertrain functions using sensor inputs
- Guarantee that tires never wear
- Replace all steering linkage
Explanation
Correct Answer
B:Best answer. Electronic controllers calculate actuations for operation and emissions.
Incorrect Answers
A:Not best. Generate all power without fuel: Controllers consume electrical energy.
C:Not best. Guarantee that tires never wear: Wear still occurs.
D:Not best. Replace all steering linkage: Controllers cannot substitute for mechanical linkage.
Question 468
Which sensor is commonly used to determine engine rotational position?
- Crankshaft position sensor
- Fuel cap
- Rain sensor
- Cabin temperature sensor
Explanation
Correct Answer
A:Best answer. Crankshaft sensing supports timing and misfire diagnostics.
Incorrect Answers
B:Not best. Fuel cap: A cap seals the tank. It does not meet the specific requirement in the question.
C:Not best. Rain sensor: This detects moisture on glass. It does not meet the specific requirement in the question.
D:Not best. Cabin temperature sensor: This measures climate conditions.
Question 469
What does a mass-airflow sensor measure?
- Mass rate of incoming air
- Brake-pad friction coefficient directly
- Road angle only
- Oil sump volume precisely
Explanation
Correct Answer
A:Best answer. The ECU uses air measurement to calculate fueling.
Incorrect Answers
B:Not best. Brake-pad friction coefficient directly: It is not a brake component.
C:Not best. Road angle only: Inclination uses inertial sensors.
D:Not best. Oil sump volume precisely: Oil level sensors are different.
Question 470
Why is an illuminated check-engine light worth diagnosing?
- It guarantees imminent engine seizure
- It proves the alternator is new
- It indicates the controller detected a fault or emissions-related issue
- It always means the fuel tank is empty
Explanation
Correct Answer
C:Best answer. Stored codes and tests help identify the cause.
Incorrect Answers
A:Not best. It guarantees imminent engine seizure: Fault severities vary.
B:Not best. It proves the alternator is new: The light is not an alternator purchase log.
D:Not best. It always means the fuel tank is empty: Fuel level has a separate warning.