cert
cert-1
cert-2

Pass CompTIA N10-009 Exam in First Attempt Guaranteed!

Get 100% Latest Exam Questions, Accurate & Verified Answers to Pass the Actual Exam!
30 Days Free Updates, Instant Download!

cert-5
cert-6
N10-009 Exam - Verified By Experts
N10-009 Premium Bundle
$29.98

N10-009 Premium Bundle

$79.99
$109.97
  • Premium File 768 Questions & Answers. Last update: Nov 13, 2026
  • Training Course 240 Video Lectures
  • Study Guide 128 Pages
 
$109.97
$79.99
accept 176 downloads in last 7 days
block-screenshots
Purchase CompTIA N10-009 Exam Training Products Individually
CompTIA N10-009 Premium File
Premium File 768 Q&A
$76.99$69.99
CompTIA N10-009 Video Training Course
Training Course 240 Lectures
$21.99 $19.99
CompTIA N10-009 PDF Study Guide
Study Guide 128 Pages
$21.99 $19.99
CompTIA N10-009 Practice Test 73

Question 720

The original case was: A switch virtual interface exists but stays down because no active ports belong to its VLAN. The requirement then changes: The SVI is active but users cannot reach the intended subnet after a route change. Which revised action BEST meets this new condition?

  1. An active allowed member port brings the SVI up and inter-VLAN tests succeed.
  2. Change the router's DNS server and expect the SVI to come up.
  3. Check route distribution and next-hop policy.
  4. Verify VLAN existence and active participating interfaces in the SVI's autostate context.

Explanation

Correct Answer

C:

An operational interface alone does not establish remote route correctness. The revised requirement is: The SVI is active but users cannot reach the intended subnet after a route change. The appropriate action is: Check route distribution and next-hop policy.

Incorrect Answers

A:

An active allowed member port brings the SVI up and inter-VLAN tests succeed. The current requirement is: The SVI is active but users cannot reach the intended subnet after a route change.

B:

DNS configuration does not activate a Layer 3 VLAN interface. It remains inappropriate in the revised context.

D:

This is the original control. An SVI may depend on operational layer-2 membership to become active. It does not directly satisfy the revised requirement: The SVI is active but users cannot reach the intended subnet after a route change.

Question 721

A site loses remote access after the default route is deleted during maintenance. Which action MOST directly meets the stated networking requirement?

  1. Assign unique addresses and enforce DHCP reservations or IPAM governance.
  2. Implement tested default-route failover with appropriate tracking.
  3. Increase SNMP polling frequency instead of restoring routes.
  4. Restore a correct tracked or approved default route toward the proper next hop.

Explanation

Correct Answer

D:

Without suitable specific or default routes, unknown destinations cannot be forwarded. This specifically resolves: A site loses remote access after the default route is deleted during maintenance.

Incorrect Answers

A:

This addresses another problem in objective 5.3: Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes.

B:

This action responds to a later condition: A second ISP is added to back up the primary provider. Multiple uplinks need deterministic route selection after failures.

C:

Monitoring frequency cannot substitute for forwarding entries. The suggested approach is: Increase SNMP polling frequency instead of restoring routes.

Question 722

A site loses remote access after the default route is deleted during maintenance. A colleague instead suggests: Increase SNMP polling frequency instead of restoring routes. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. Monitoring frequency cannot substitute for forwarding entries.
  2. Name aliases cannot make identical IPv4 host identities unambiguous.
  3. Multiple uplinks need deterministic route selection after failures.
  4. Without suitable specific or default routes, unknown destinations cannot be forwarded.

Explanation

Correct Answer

A:

Monitoring frequency cannot substitute for forwarding entries. This flaw directly concerns the proposed action: Increase SNMP polling frequency instead of restoring routes.

Incorrect Answers

B:

This flaw concerns a different case in objective 5.3: Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes. The current rejected proposal is: Increase SNMP polling frequency instead of restoring routes.

C:

This rationale belongs to a later changed condition: A second ISP is added to back up the primary provider.

D:

This explains why the recommended control works: Restore a correct tracked or approved default route toward the proper next hop.

Question 723

A site loses remote access after the default route is deleted during maintenance. After applying the solution 'Restore a correct tracked or approved default route toward the proper next hop.', which observation MOST directly proves that the requirement was met?

  1. Routing table shows a valid default and controlled remote reachability succeeds.
  2. The client reaches an external test IP after correcting its gateway.
  3. ARP stability returns after each printer has a unique documented address.
  4. Approval is recorded for 'Restore a correct tracked or approved default route toward the proper next hop.' but no operational validation is performed.

Explanation

Correct Answer

A:

Routing table shows a valid default and controlled remote reachability succeeds. It tests the intended outcome because without suitable specific or default routes, unknown destinations cannot be forwarded.

Incorrect Answers

B:

This test addresses a separate problem: A client can reach hosts in its own VLAN but cannot reach any remote subnet after an addressing change.

C:

This observation is for a different condition: Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes. It does not directly test the target outcome: A site loses remote access after the default route is deleted during maintenance.

D:

The missing direct test is: Routing table shows a valid default and controlled remote reachability succeeds.

Question 724

The original case was: A site loses remote access after the default route is deleted during maintenance. The requirement then changes: A second ISP is added to back up the primary provider. Which revised action BEST meets this new condition?

  1. Restore a correct tracked or approved default route toward the proper next hop.
  2. Implement tested default-route failover with appropriate tracking.
  3. Routing table shows a valid default and controlled remote reachability succeeds.
  4. Increase SNMP polling frequency instead of restoring routes.

Explanation

Correct Answer

B:

Multiple uplinks need deterministic route selection after failures. The revised requirement is: A second ISP is added to back up the primary provider. The appropriate action is: Implement tested default-route failover with appropriate tracking.

Incorrect Answers

A:

This is the original control. Without suitable specific or default routes, unknown destinations cannot be forwarded. It does not directly satisfy the revised requirement: A second ISP is added to back up the primary provider.

C:

Routing table shows a valid default and controlled remote reachability succeeds. The current requirement is: A second ISP is added to back up the primary provider.

D:

Monitoring frequency cannot substitute for forwarding entries. It remains inappropriate in the revised context.

Question 725

Video meetings stutter during backup jobs when a shared WAN link hits full utilization. Which TWO entries together specify the appropriate corrective measure AND the strongest direct evidence that it works? (Select TWO.)

  1. Identify congestion and apply QoS plus capacity planning for time-sensitive traffic.
  2. Change the VPN hostname and assume the overloaded link gains capacity.
  3. Under the same backup load, voice latency and loss stay within targets.
  4. Perform spectrum survey and reassign suitable nonoverlapping channels and power.
  5. Tune queue policies and measure burst behavior at the actual bottleneck.

Explanation

Correct Answers

A:

Correct control. Bulk data may saturate queues and increase voice/video jitter and delay. It addresses the present requirement: Video meetings stutter during backup jobs when a shared WAN link hits full utilization.

C:

Correct verification. Under the same backup load, voice latency and loss stay within targets. This demonstrates the outcome expected from: Identify congestion and apply QoS plus capacity planning for time-sensitive traffic.

Incorrect Answers

B:

Incorrect control. Name changes do not reduce physical bandwidth contention. The inappropriate proposal is: Change the VPN hostname and assume the overloaded link gains capacity.

D:

This control fits another scenario in objective 5.4: A wireless office suffers retries on 2.4GHz where neighboring APs use overlapping channels. It does not directly verify or implement the present issue.

E:

This is a response to a different later requirement: The organization buys a higher-capacity link but still sees bursts on one queue. Capacity alone may not correct unfair queue scheduling. It is not the original control-and-evidence pair.

Question 726

Video meetings stutter during backup jobs when a shared WAN link hits full utilization. A colleague instead suggests: Change the VPN hostname and assume the overloaded link gains capacity. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. Name changes do not reduce physical bandwidth contention.
  2. Bulk data may saturate queues and increase voice/video jitter and delay.
  3. Excessive power and overlap can worsen interference.
  4. Capacity alone may not correct unfair queue scheduling.

Explanation

Correct Answer

A:

Name changes do not reduce physical bandwidth contention. This flaw directly concerns the proposed action: Change the VPN hostname and assume the overloaded link gains capacity.

Incorrect Answers

B:

This explains why the recommended control works: Identify congestion and apply QoS plus capacity planning for time-sensitive traffic.

C:

This flaw concerns a different case in objective 5.4: A wireless office suffers retries on 2.4GHz where neighboring APs use overlapping channels. The current rejected proposal is: Change the VPN hostname and assume the overloaded link gains capacity.

D:

This rationale belongs to a later changed condition: The organization buys a higher-capacity link but still sees bursts on one queue.

Question 727

Video meetings stutter during backup jobs when a shared WAN link hits full utilization. After applying the solution 'Identify congestion and apply QoS plus capacity planning for time-sensitive traffic.', which observation MOST directly proves that the requirement was met?

  1. Approval is recorded for 'Identify congestion and apply QoS plus capacity planning for time-sensitive traffic.' but no operational validation is performed.
  2. Retry rates and throughput improve after the corrected channel plan.
  3. Under the same backup load, voice latency and loss stay within targets.
  4. Coverage measurements and long-running client tests show a reliable link.

Explanation

Correct Answer

C:

Under the same backup load, voice latency and loss stay within targets. It tests the intended outcome because bulk data may saturate queues and increase voice/video jitter and delay.

Incorrect Answers

A:

Approval alone does not demonstrate operating effectiveness. The missing direct test is: Under the same backup load, voice latency and loss stay within targets.

B:

This observation is for a different condition: A wireless office suffers retries on 2.4GHz where neighboring APs use overlapping channels. It does not directly test the target outcome: Video meetings stutter during backup jobs when a shared WAN link hits full utilization.

D:

This test addresses a separate problem: Employees at the far end of a warehouse cannot maintain a stable wireless connection despite clean channels.

Question 728

The original case was: Video meetings stutter during backup jobs when a shared WAN link hits full utilization. The requirement then changes: The organization buys a higher-capacity link but still sees bursts on one queue. Which revised action BEST meets this new condition?

  1. Under the same backup load, voice latency and loss stay within targets.
  2. Tune queue policies and measure burst behavior at the actual bottleneck.
  3. Change the VPN hostname and assume the overloaded link gains capacity.
  4. Identify congestion and apply QoS plus capacity planning for time-sensitive traffic.

Explanation

Correct Answer

B:

Capacity alone may not correct unfair queue scheduling. The revised requirement is: The organization buys a higher-capacity link but still sees bursts on one queue. The appropriate action is: Tune queue policies and measure burst behavior at the actual bottleneck.

Incorrect Answers

A:

Under the same backup load, voice latency and loss stay within targets. The current requirement is: The organization buys a higher-capacity link but still sees bursts on one queue.

C:

Name changes do not reduce physical bandwidth contention. It remains inappropriate in the revised context.

D:

This is the original control. Bulk data may saturate queues and increase voice/video jitter and delay. It does not directly satisfy the revised requirement: The organization buys a higher-capacity link but still sees bursts on one queue.

Question 729

A cloud app reports highly variable round-trip delay even though average bandwidth seems adequate. Which action MOST directly meets the stated networking requirement?

  1. Investigate discard counters, errors and path saturation.
  2. Report only the link's nominal 1G port speed as proof of good application response.
  3. Measure latency variation and per-hop congestion rather than only speed-test throughput.
  4. Survey signal and noise and adjust AP placement or antenna pattern.

Explanation

Correct Answer

C:

Jitter affects time-sensitive applications even with sufficient average capacity. This specifically resolves: A cloud app reports highly variable round-trip delay even though average bandwidth seems adequate.

Incorrect Answers

A:

This action responds to a later condition: Packet traces show intermittent loss instead of delay variation as the dominant issue. Loss analysis targets missing packets rather than variation among arrived packets.

B:

Physical port rate does not establish end-to-end latency or jitter. The suggested approach is: Report only the link's nominal 1G port speed as proof of good application response.

D:

This addresses another problem in objective 5.4: Employees at the far end of a warehouse cannot maintain a stable wireless connection despite clean channels.

Question 730

A cloud app reports highly variable round-trip delay even though average bandwidth seems adequate. A colleague instead suggests: Report only the link's nominal 1G port speed as proof of good application response. Which finding MOST specifically explains why that suggestion is unsuitable?

  1. Physical port rate does not establish end-to-end latency or jitter.
  2. Loss analysis targets missing packets rather than variation among arrived packets.
  3. Name configuration cannot compensate for physical RF attenuation.
  4. Jitter affects time-sensitive applications even with sufficient average capacity.

Explanation

Correct Answer

A:

Physical port rate does not establish end-to-end latency or jitter. This flaw directly concerns the proposed action: Report only the link's nominal 1G port speed as proof of good application response.

Incorrect Answers

B:

This rationale belongs to a later changed condition: Packet traces show intermittent loss instead of delay variation as the dominant issue.

C:

This flaw concerns a different case in objective 5.4: Employees at the far end of a warehouse cannot maintain a stable wireless connection despite clean channels. The current rejected proposal is: Report only the link's nominal 1G port speed as proof of good application response.

D:

This explains why the recommended control works: Measure latency variation and per-hop congestion rather than only speed-test throughput.

CompTIA Network+ (N10-009) Practice Tests