CompTIA N10-009 Practice Test 72
Question 710
Two redundant switches intermittently form a forwarding loop after a spanning-tree priority change. A colleague instead suggests: Disable spanning tree across all redundant Ethernet paths. Which finding MOST specifically explains why that suggestion is unsuitable?
- Aggregation differs from STP handling of independent redundant links.
- Incorrect STP topology can allow loops or unwanted blocked forwarding paths.
- Disabling loop prevention may worsen broadcast storms.
- DNS configuration does not activate a Layer 3 VLAN interface.
Explanation
Correct Answer
C:Disabling loop prevention may worsen broadcast storms. This flaw directly concerns the proposed action: Disable spanning tree across all redundant Ethernet paths.
Incorrect Answers
A:This rationale belongs to a later changed condition: A high-bandwidth connection needs multiple parallel active links.
B:This explains why the recommended control works: Inspect STP root roles and blocked interfaces and correct the root configuration.
D:This flaw concerns a different case in objective 5.3: A switch virtual interface exists but stays down because no active ports belong to its VLAN. The current rejected proposal is: Disable spanning tree across all redundant Ethernet paths.
Question 711
Two redundant switches intermittently form a forwarding loop after a spanning-tree priority change. After applying the solution 'Inspect STP root roles and blocked interfaces and correct the root configuration.', which observation MOST directly proves that the requirement was met?
- An active allowed member port brings the SVI up and inter-VLAN tests succeed.
- Routing table shows a valid default and controlled remote reachability succeeds.
- Topology events settle and MAC flapping stops after restoring appropriate root roles.
- Approval is recorded for 'Inspect STP root roles and blocked interfaces and correct the root configuration.' but no operational validation is performed.
Explanation
Correct Answer
C:Topology events settle and MAC flapping stops after restoring appropriate root roles. It tests the intended outcome because incorrect stp topology can allow loops or unwanted blocked forwarding paths.
Incorrect Answers
A:This observation is for a different condition: A switch virtual interface exists but stays down because no active ports belong to its VLAN. It does not directly test the target outcome: Two redundant switches intermittently form a forwarding loop after a spanning-tree priority change.
B:This test addresses a separate problem: A site loses remote access after the default route is deleted during maintenance.
D:The missing direct test is: Topology events settle and MAC flapping stops after restoring appropriate root roles.
Question 712
The original case was: Two redundant switches intermittently form a forwarding loop after a spanning-tree priority change. The requirement then changes: A high-bandwidth connection needs multiple parallel active links. Which revised action BEST meets this new condition?
- Disable spanning tree across all redundant Ethernet paths.
- Topology events settle and MAC flapping stops after restoring appropriate root roles.
- Inspect STP root roles and blocked interfaces and correct the root configuration.
- Build an approved LACP port channel to avoid separate looped links.
Explanation
Correct Answer
D:Aggregation differs from STP handling of independent redundant links. The revised requirement is: A high-bandwidth connection needs multiple parallel active links. The appropriate action is: Build an approved LACP port channel to avoid separate looped links.
Incorrect Answers
A:Disabling loop prevention may worsen broadcast storms. It remains inappropriate in the revised context.
B:Topology events settle and MAC flapping stops after restoring appropriate root roles. The current requirement is: A high-bandwidth connection needs multiple parallel active links.
C:This is the original control. Incorrect STP topology can allow loops or unwanted blocked forwarding paths. It does not directly satisfy the revised requirement: A high-bandwidth connection needs multiple parallel active links.
Question 713
An inter-VLAN ACL denies an authorized application even though IP routing and ARP work. Which action MOST directly meets the stated networking requirement?
- Use policy-aware URL or content filtering rather than only static addresses.
- Review ACL evaluation order and match source, destination, protocol and port.
- Reconfigure physical cable pairs without inspecting policy matches.
- Restore a correct tracked or approved default route toward the proper next hop.
Explanation
Correct Answer
B:An earlier deny can shadow later permit rules on the routed path. This specifically resolves: An inter-VLAN ACL denies an authorized application even though IP routing and ARP work.
Incorrect Answers
A:This action responds to a later condition: The access requirement is for a public web domain category instead of a fixed IP. Domain categories require controls that understand URL context.
C:Layer-1 repairs are unlikely where routing works and ACL counters show denies. The suggested approach is: Reconfigure physical cable pairs without inspecting policy matches.
D:This addresses another problem in objective 5.3: A site loses remote access after the default route is deleted during maintenance.
Question 714
An inter-VLAN ACL denies an authorized application even though IP routing and ARP work. A colleague instead suggests: Reconfigure physical cable pairs without inspecting policy matches. Which finding MOST specifically explains why that suggestion is unsuitable?
- Monitoring frequency cannot substitute for forwarding entries.
- Layer-1 repairs are unlikely where routing works and ACL counters show denies.
- An earlier deny can shadow later permit rules on the routed path.
- Domain categories require controls that understand URL context.
Explanation
Correct Answer
B:Layer-1 repairs are unlikely where routing works and ACL counters show denies. This flaw directly concerns the proposed action: Reconfigure physical cable pairs without inspecting policy matches.
Incorrect Answers
A:This flaw concerns a different case in objective 5.3: A site loses remote access after the default route is deleted during maintenance. The current rejected proposal is: Reconfigure physical cable pairs without inspecting policy matches.
C:This explains why the recommended control works: Review ACL evaluation order and match source, destination, protocol and port.
D:This rationale belongs to a later changed condition: The access requirement is for a public web domain category instead of a fixed IP.
Question 715
An inter-VLAN ACL denies an authorized application even though IP routing and ARP work. After applying the solution 'Review ACL evaluation order and match source, destination, protocol and port.', which observation MOST directly proves that the requirement was met?
- Routing table shows a valid default and controlled remote reachability succeeds.
- Approved packets pass and unauthorized flows remain blocked after rule correction.
- VLAN and DHCP diagnostics confirm the client gets an address from the correct scope.
- Approval is recorded for 'Review ACL evaluation order and match source, destination, protocol and port.' but no operational validation is performed.
Explanation
Correct Answer
B:Approved packets pass and unauthorized flows remain blocked after rule correction. It tests the intended outcome because an earlier deny can shadow later permit rules on the routed path.
Incorrect Answers
A:This observation is for a different condition: A site loses remote access after the default route is deleted during maintenance. It does not directly test the target outcome: An inter-VLAN ACL denies an authorized application even though IP routing and ARP work.
C:This test addresses a separate problem: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope.
D:The missing direct test is: Approved packets pass and unauthorized flows remain blocked after rule correction.
Question 716
The original case was: An inter-VLAN ACL denies an authorized application even though IP routing and ARP work. The requirement then changes: The access requirement is for a public web domain category instead of a fixed IP. Which revised action BEST meets this new condition?
- Use policy-aware URL or content filtering rather than only static addresses.
- Approved packets pass and unauthorized flows remain blocked after rule correction.
- Reconfigure physical cable pairs without inspecting policy matches.
- Review ACL evaluation order and match source, destination, protocol and port.
Explanation
Correct Answer
A:Domain categories require controls that understand URL context. The revised requirement is: The access requirement is for a public web domain category instead of a fixed IP. The appropriate action is: Use policy-aware URL or content filtering rather than only static addresses.
Incorrect Answers
B:Approved packets pass and unauthorized flows remain blocked after rule correction. The current requirement is: The access requirement is for a public web domain category instead of a fixed IP.
C:Layer-1 repairs are unlikely where routing works and ACL counters show denies. It remains inappropriate in the revised context.
D:This is the original control. An earlier deny can shadow later permit rules on the routed path. It does not directly satisfy the revised requirement: The access requirement is for a public web domain category instead of a fixed IP.
Question 717
A switch virtual interface exists but stays down because no active ports belong to its VLAN. Which action MOST directly meets the stated networking requirement?
- Change the router's DNS server and expect the SVI to come up.
- Verify VLAN existence and active participating interfaces in the SVI's autostate context.
- Check access VLAN membership, relay target and DHCP scope configuration.
- Check route distribution and next-hop policy.
Explanation
Correct Answer
B:An SVI may depend on operational layer-2 membership to become active. This specifically resolves: A switch virtual interface exists but stays down because no active ports belong to its VLAN.
Incorrect Answers
A:DNS configuration does not activate a Layer 3 VLAN interface. The suggested approach is: Change the router's DNS server and expect the SVI to come up.
C:This addresses another problem in objective 5.3: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope.
D:This action responds to a later condition: The SVI is active but users cannot reach the intended subnet after a route change. An operational interface alone does not establish remote route correctness.
Question 718
A switch virtual interface exists but stays down because no active ports belong to its VLAN. A colleague instead suggests: Change the router's DNS server and expect the SVI to come up. Which finding MOST specifically explains why that suggestion is unsuitable?
- An operational interface alone does not establish remote route correctness.
- An SVI may depend on operational layer-2 membership to become active.
- DNS configuration does not activate a Layer 3 VLAN interface.
- Application proxy settings cannot choose the proper subnet lease source.
Explanation
Correct Answer
C:DNS configuration does not activate a Layer 3 VLAN interface. This flaw directly concerns the proposed action: Change the router's DNS server and expect the SVI to come up.
Incorrect Answers
A:This rationale belongs to a later changed condition: The SVI is active but users cannot reach the intended subnet after a route change.
B:This explains why the recommended control works: Verify VLAN existence and active participating interfaces in the SVI's autostate context.
D:This flaw concerns a different case in objective 5.3: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope. The current rejected proposal is: Change the router's DNS server and expect the SVI to come up.
Question 719
A switch virtual interface exists but stays down because no active ports belong to its VLAN. After applying the solution 'Verify VLAN existence and active participating interfaces in the SVI's autostate context.', which observation MOST directly proves that the requirement was met?
- An active allowed member port brings the SVI up and inter-VLAN tests succeed.
- VLAN and DHCP diagnostics confirm the client gets an address from the correct scope.
- Approval is recorded for 'Verify VLAN existence and active participating interfaces in the SVI's autostate context.' but no operational validation is performed.
- ARP stability returns after each printer has a unique documented address.
Explanation
Correct Answer
A:An active allowed member port brings the SVI up and inter-VLAN tests succeed. It tests the intended outcome because an svi may depend on operational layer-2 membership to become active.
Incorrect Answers
B:This observation is for a different condition: A client is placed in VLAN 40 but receives an IP address from the VLAN 50 DHCP scope. It does not directly test the target outcome: A switch virtual interface exists but stays down because no active ports belong to its VLAN.
C:The missing direct test is: An active allowed member port brings the SVI up and inter-VLAN tests succeed.
D:This test addresses a separate problem: Two printers are manually configured with the same IPv4 address and clients experience intermittent ARP changes.
Question 720
The original case was: A switch virtual interface exists but stays down because no active ports belong to its VLAN. The requirement then changes: The SVI is active but users cannot reach the intended subnet after a route change. Which revised action BEST meets this new condition?
- An active allowed member port brings the SVI up and inter-VLAN tests succeed.
- Change the router's DNS server and expect the SVI to come up.
- Check route distribution and next-hop policy.
- Verify VLAN existence and active participating interfaces in the SVI's autostate context.
Explanation
Correct Answer
C:An operational interface alone does not establish remote route correctness. The revised requirement is: The SVI is active but users cannot reach the intended subnet after a route change. The appropriate action is: Check route distribution and next-hop policy.
Incorrect Answers
A:An active allowed member port brings the SVI up and inter-VLAN tests succeed. The current requirement is: The SVI is active but users cannot reach the intended subnet after a route change.
B:DNS configuration does not activate a Layer 3 VLAN interface. It remains inappropriate in the revised context.
D:This is the original control. An SVI may depend on operational layer-2 membership to become active. It does not directly satisfy the revised requirement: The SVI is active but users cannot reach the intended subnet after a route change.