CompTIA N10-009 Practice Test 2
Question 10
An application needs reliable in-order byte delivery despite packet drops over an overloaded link. A colleague instead suggests: Assume bare UDP guarantees stream order and retransmits losses. Which finding MOST specifically explains why that suggestion is unsuitable?
- UDP alone does not provide ordered reliable stream semantics.
- Transport-port changes cannot repair a missing physical signal.
- TCP recovers lost segments and delivers an ordered stream to the application.
- Real-time streams often prefer timely arrival over delayed reliable delivery.
Explanation
Correct Answer
A:UDP alone does not provide ordered reliable stream semantics. This flaw directly concerns the proposed action: Assume bare UDP guarantees stream order and retransmits losses.
Incorrect Answers
B:This flaw concerns a different case in objective 1.1: A workstation reports link down even though the application is correctly configured and DNS resolves. The current rejected proposal is: Assume bare UDP guarantees stream order and retransmits losses.
C:This explains why the recommended control works: Use TCP sequencing, acknowledgment, and retransmission where the application requires reliable ordering.
D:This rationale belongs to a later changed condition: The workload switches to time-sensitive voice with low tolerance for retransmission delay.
Question 11
An application needs reliable in-order byte delivery despite packet drops over an overloaded link. After applying the solution 'Use TCP sequencing, acknowledgment, and retransmission where the application requires reliable ordering.', which observation MOST directly proves that the requirement was met?
- The learned MAC maps the destination to the correct port and the frame reaches it.
- Interface status becomes up after the physical problem is corrected.
- Approval is recorded for 'Use TCP sequencing, acknowledgment, and retransmission where the application requires reliable ordering.' but no operational validation is performed.
- Controlled loss testing shows successful transfer integrity and retransmissions.
Explanation
Correct Answer
D:Controlled loss testing shows successful transfer integrity and retransmissions. It tests the intended outcome because tcp recovers lost segments and delivers an ordered stream to the application.
Incorrect Answers
A:This test addresses a separate problem: A switch forwards a frame within the same VLAN based on the destination hardware address, independent of an IP route.
B:This observation is for a different condition: A workstation reports link down even though the application is correctly configured and DNS resolves. It does not directly test the target outcome: An application needs reliable in-order byte delivery despite packet drops over an overloaded link.
C:The missing direct test is: Controlled loss testing shows successful transfer integrity and retransmissions.
Question 12
The original case was: An application needs reliable in-order byte delivery despite packet drops over an overloaded link. The requirement then changes: The workload switches to time-sensitive voice with low tolerance for retransmission delay. Which revised action BEST meets this new condition?
- Use TCP sequencing, acknowledgment, and retransmission where the application requires reliable ordering.
- Choose a latency-oriented transport and design the application to handle loss.
- Controlled loss testing shows successful transfer integrity and retransmissions.
- Assume bare UDP guarantees stream order and retransmits losses.
Explanation
Correct Answer
B:Real-time streams often prefer timely arrival over delayed reliable delivery. The revised requirement is: The workload switches to time-sensitive voice with low tolerance for retransmission delay. The appropriate action is: Choose a latency-oriented transport and design the application to handle loss.
Incorrect Answers
A:This is the original control. TCP recovers lost segments and delivers an ordered stream to the application. It does not directly satisfy the revised requirement: The workload switches to time-sensitive voice with low tolerance for retransmission delay.
C:Controlled loss testing shows successful transfer integrity and retransmissions. The current requirement is: The workload switches to time-sensitive voice with low tolerance for retransmission delay.
D:UDP alone does not provide ordered reliable stream semantics. It remains inappropriate in the revised context.
Question 13
A technician must identify whether an HTTPS record is encrypted at Ethernet signaling or in a higher-layer protocol. Which action MOST directly meets the stated networking requirement?
- Troubleshoot physical media and interface signaling before TLS configuration.
- Locate TLS protection above transport instead of attributing it to physical Ethernet signaling.
- Treat an RJ45 electrical signal as the TLS encryption function.
- Inspect the destination MAC and learned switching table for that VLAN.
Explanation
Correct Answer
B:TLS protects application exchanges and is not performed by the copper physical layer. This specifically resolves: A technician must identify whether an HTTPS record is encrypted at Ethernet signaling or in a higher-layer protocol.
Incorrect Answers
A:This action responds to a later condition: The same link is down before Ethernet negotiation occurs. No higher-layer session succeeds without physical connectivity.
C:A physical-layer signal contains no intrinsic application-layer TLS processing. The suggested approach is: Treat an RJ45 electrical signal as the TLS encryption function.
D:This addresses another problem in objective 1.1: A switch forwards a frame within the same VLAN based on the destination hardware address, independent of an IP route.
Question 14
A technician must identify whether an HTTPS record is encrypted at Ethernet signaling or in a higher-layer protocol. A colleague instead suggests: Treat an RJ45 electrical signal as the TLS encryption function. Which finding MOST specifically explains why that suggestion is unsuitable?
- No higher-layer session succeeds without physical connectivity.
- TLS protects application exchanges and is not performed by the copper physical layer.
- TCP or UDP source ports are not normal Layer 2 forwarding keys.
- A physical-layer signal contains no intrinsic application-layer TLS processing.
Explanation
Correct Answer
D:A physical-layer signal contains no intrinsic application-layer TLS processing. This flaw directly concerns the proposed action: Treat an RJ45 electrical signal as the TLS encryption function.
Incorrect Answers
A:This rationale belongs to a later changed condition: The same link is down before Ethernet negotiation occurs.
B:This explains why the recommended control works: Locate TLS protection above transport instead of attributing it to physical Ethernet signaling.
C:This flaw concerns a different case in objective 1.1: A switch forwards a frame within the same VLAN based on the destination hardware address, independent of an IP route. The current rejected proposal is: Treat an RJ45 electrical signal as the TLS encryption function.
Question 15
A technician must identify whether an HTTPS record is encrypted at Ethernet signaling or in a higher-layer protocol. After applying the solution 'Locate TLS protection above transport instead of attributing it to physical Ethernet signaling.', which observation MOST directly proves that the requirement was met?
- Approval is recorded for 'Locate TLS protection above transport instead of attributing it to physical Ethernet signaling.' but no operational validation is performed.
- The learned MAC maps the destination to the correct port and the frame reaches it.
- Captures across a routed hop show new Ethernet addresses while the destination IP stays consistent.
- A protocol decode identifies Ethernet, IP, TCP and TLS records separately.
Explanation
Correct Answer
D:A protocol decode identifies Ethernet, IP, TCP and TLS records separately. It tests the intended outcome because tls protects application exchanges and is not performed by the copper physical layer.
Incorrect Answers
A:The missing direct test is: A protocol decode identifies Ethernet, IP, TCP and TLS records separately.
B:This observation is for a different condition: A switch forwards a frame within the same VLAN based on the destination hardware address, independent of an IP route. It does not directly test the target outcome: A technician must identify whether an HTTPS record is encrypted at Ethernet signaling or in a higher-layer protocol.
C:This test addresses a separate problem: A router forwards a packet across a new Ethernet segment with a different link header but the destination IP unchanged.
Question 16
The original case was: A technician must identify whether an HTTPS record is encrypted at Ethernet signaling or in a higher-layer protocol. The requirement then changes: The same link is down before Ethernet negotiation occurs. Which revised action BEST meets this new condition?
- Treat an RJ45 electrical signal as the TLS encryption function.
- Locate TLS protection above transport instead of attributing it to physical Ethernet signaling.
- Troubleshoot physical media and interface signaling before TLS configuration.
- A protocol decode identifies Ethernet, IP, TCP and TLS records separately.
Explanation
Correct Answer
C:No higher-layer session succeeds without physical connectivity. The revised requirement is: The same link is down before Ethernet negotiation occurs. The appropriate action is: Troubleshoot physical media and interface signaling before TLS configuration.
Incorrect Answers
A:A physical-layer signal contains no intrinsic application-layer TLS processing. It remains inappropriate in the revised context.
B:This is the original control. TLS protects application exchanges and is not performed by the copper physical layer. It does not directly satisfy the revised requirement: The same link is down before Ethernet negotiation occurs.
D:A protocol decode identifies Ethernet, IP, TCP and TLS records separately. The current requirement is: The same link is down before Ethernet negotiation occurs.
Question 17
A workstation reports link down even though the application is correctly configured and DNS resolves. Which action MOST directly meets the stated networking requirement?
- Change the web application port before checking cable continuity.
- Start at OSI Layer 1 with power, connector seating and link state.
- Inspect VLAN membership and the Layer 2 MAC address table.
- Resolve the next-hop MAC and rewrite link-layer encapsulation at each routed hop.
Explanation
Correct Answer
B:An absent physical link prevents upper-layer protocols from exchanging traffic. This specifically resolves: A workstation reports link down even though the application is correctly configured and DNS resolves.
Incorrect Answers
A:Transport-port changes cannot repair a missing physical signal. The suggested approach is: Change the web application port before checking cable continuity.
C:This action responds to a later condition: Link comes up but local switching still forwards to an unexpected port. A working physical circuit does not ensure correct data-link forwarding.
D:This addresses another problem in objective 1.1: A router forwards a packet across a new Ethernet segment with a different link header but the destination IP unchanged.
Question 18
A workstation reports link down even though the application is correctly configured and DNS resolves. A colleague instead suggests: Change the web application port before checking cable continuity. Which finding MOST specifically explains why that suggestion is unsuitable?
- An absent physical link prevents upper-layer protocols from exchanging traffic.
- A working physical circuit does not ensure correct data-link forwarding.
- Ethernet MAC destinations are meaningful only on the current link.
- Transport-port changes cannot repair a missing physical signal.
Explanation
Correct Answer
D:Transport-port changes cannot repair a missing physical signal. This flaw directly concerns the proposed action: Change the web application port before checking cable continuity.
Incorrect Answers
A:This explains why the recommended control works: Start at OSI Layer 1 with power, connector seating and link state.
B:This rationale belongs to a later changed condition: Link comes up but local switching still forwards to an unexpected port.
C:This flaw concerns a different case in objective 1.1: A router forwards a packet across a new Ethernet segment with a different link header but the destination IP unchanged. The current rejected proposal is: Change the web application port before checking cable continuity.
Question 19
A workstation reports link down even though the application is correctly configured and DNS resolves. After applying the solution 'Start at OSI Layer 1 with power, connector seating and link state.', which observation MOST directly proves that the requirement was met?
- Captures across a routed hop show new Ethernet addresses while the destination IP stays consistent.
- Approval is recorded for 'Start at OSI Layer 1 with power, connector seating and link state.' but no operational validation is performed.
- Controlled loss testing shows successful transfer integrity and retransmissions.
- Interface status becomes up after the physical problem is corrected.
Explanation
Correct Answer
D:Interface status becomes up after the physical problem is corrected. It tests the intended outcome because an absent physical link prevents upper-layer protocols from exchanging traffic.
Incorrect Answers
A:This observation is for a different condition: A router forwards a packet across a new Ethernet segment with a different link header but the destination IP unchanged. It does not directly test the target outcome: A workstation reports link down even though the application is correctly configured and DNS resolves.
B:Approval alone does not demonstrate operating effectiveness. The missing direct test is: Interface status becomes up after the physical problem is corrected.
C:This test addresses a separate problem: An application needs reliable in-order byte delivery despite packet drops over an overloaded link.
Question 20
The original case was: A workstation reports link down even though the application is correctly configured and DNS resolves. The requirement then changes: Link comes up but local switching still forwards to an unexpected port. Which revised action BEST meets this new condition?
- Interface status becomes up after the physical problem is corrected.
- Change the web application port before checking cable continuity.
- Inspect VLAN membership and the Layer 2 MAC address table.
- Start at OSI Layer 1 with power, connector seating and link state.
Explanation
Correct Answer
C:A working physical circuit does not ensure correct data-link forwarding. The revised requirement is: Link comes up but local switching still forwards to an unexpected port. The appropriate action is: Inspect VLAN membership and the Layer 2 MAC address table.
Incorrect Answers
A:Interface status becomes up after the physical problem is corrected. The current requirement is: Link comes up but local switching still forwards to an unexpected port.
B:Transport-port changes cannot repair a missing physical signal. It remains inappropriate in the revised context.
D:This is the original control. An absent physical link prevents upper-layer protocols from exchanging traffic. It does not directly satisfy the revised requirement: Link comes up but local switching still forwards to an unexpected port.