CompTIA N10-009 Practice Test 15
Question 140
The original case was: New office hosts consistently self-assign 169.254.x.x addresses and cannot reach a configured DHCP server. The requirement then changes: The office permanently isolates a device network with no address server. Which revised action BEST meets this new condition?
- Treat 169.254.x.x as a normal globally routable WAN allocation.
- Successful DHCP exchange replaces the link-local address with a valid scoped lease.
- Consider controlled static addressing with documented subnets and gateways.
- Investigate missing DHCP lease service or relay reachability before assigning APIPA as a production route.
Explanation
Correct Answer
C:A deliberately isolated static network can operate without relying on DHCP. The revised requirement is: The office permanently isolates a device network with no address server. The appropriate action is: Consider controlled static addressing with documented subnets and gateways.
Incorrect Answers
A:IPv4 link-local space is not intended for routable corporate internetworks. It remains inappropriate in the revised context.
B:Successful DHCP exchange replaces the link-local address with a valid scoped lease. The current requirement is: The office permanently isolates a device network with no address server.
D:This is the original control. 169.254/16 link-local IPv4 addresses commonly indicate DHCP failure or no usable manual configuration. It does not directly satisfy the revised requirement: The office permanently isolates a device network with no address server.
Question 141
A finance team chooses 10.44.16.0/23 for a private routed segment in a corporate site. Which action MOST directly meets the stated networking requirement?
- Use properly allocated public addressing behind controlled edge protection or translation.
- Announce the 10.44.16.0/23 block as a public internet-owned aggregate.
- Validate the range as private RFC1918 space and reserve it in IP address management.
- Recheck the gateway against the /27 subnet boundary and configure an on-link gateway.
Explanation
Correct Answer
C:Correct. 10.0.0.0/8 is private space, and subnet tracking prevents overlap. This specifically resolves: A finance team chooses 10.44.16.0/23 for a private routed segment in a corporate site.
Incorrect Answers
A:This action responds to a later condition: The service must be reachable as a public internet application. Public reachability needs legitimately routable prefixes or managed translation.
B:RFC1918 private ranges are not globally routed public address assignments. The suggested approach is: Announce the 10.44.16.0/23 block as a public internet-owned aggregate.
D:This addresses another problem in objective 1.7: An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65.
Question 142
A finance team chooses 10.44.16.0/23 for a private routed segment in a corporate site. A colleague instead suggests: Announce the 10.44.16.0/23 block as a public internet-owned aggregate. Which finding MOST specifically explains why that suggestion is unsuitable?
- RFC1918 private ranges are not globally routed public address assignments.
- 10.0.0.0/8 is private space, and subnet tracking prevents overlap.
- An ordinary host cannot ARP for an off-link gateway under standard subnet rules.
- Public reachability needs legitimately routable prefixes or managed translation.
Explanation
Correct Answer
A:RFC1918 private ranges are not globally routed public address assignments. This flaw directly concerns the proposed action: Announce the 10.44.16.0/23 block as a public internet-owned aggregate.
Incorrect Answers
B:This explains why the recommended control works: Validate the range as private RFC1918 space and reserve it in IP address management.
C:This flaw concerns a different case in objective 1.7: An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65. The current rejected proposal is: Announce the 10.44.16.0/23 block as a public internet-owned aggregate.
D:This rationale belongs to a later changed condition: The service must be reachable as a public internet application.
Question 143
A finance team chooses 10.44.16.0/23 for a private routed segment in a corporate site. After applying the solution 'Validate the range as private RFC1918 space and reserve it in IP address management.', which observation MOST directly proves that the requirement was met?
- The host reaches its gateway after using a valid address in its connected subnet.
- Approval is recorded for 'Validate the range as private RFC1918 space and reserve it in IP address management.' but no operational validation is performed.
- IPAM and internal routers agree on nonoverlapping allocation and route advertisement.
- The subnet inventory fits within the allocated /27 usable host range.
Explanation
Correct Answer
C:IPAM and internal routers agree on nonoverlapping allocation and route advertisement. It tests the intended outcome because 10.0.0.0/8 is private space, and subnet tracking prevents overlap.
Incorrect Answers
A:This observation is for a different condition: An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65. It does not directly test the target outcome: A finance team chooses 10.44.16.0/23 for a private routed segment in a corporate site.
B:The missing direct test is: IPAM and internal routers agree on nonoverlapping allocation and route advertisement.
D:This test addresses a separate problem: A subnet must host 25 IPv4 devices using the smallest conventional subnet with network and broadcast addresses.
Question 144
The original case was: A finance team chooses 10.44.16.0/23 for a private routed segment in a corporate site. The requirement then changes: The service must be reachable as a public internet application. Which revised action BEST meets this new condition?
- Use properly allocated public addressing behind controlled edge protection or translation.
- IPAM and internal routers agree on nonoverlapping allocation and route advertisement.
- Validate the range as private RFC1918 space and reserve it in IP address management.
- Announce the 10.44.16.0/23 block as a public internet-owned aggregate.
Explanation
Correct Answer
A:Public reachability needs legitimately routable prefixes or managed translation. The revised requirement is: The service must be reachable as a public internet application. The appropriate action is: Use properly allocated public addressing behind controlled edge protection or translation.
Incorrect Answers
B:IPAM and internal routers agree on nonoverlapping allocation and route advertisement. The current requirement is: The service must be reachable as a public internet application.
C:This is the original control. 10.0.0.0/8 is private space, and subnet tracking prevents overlap. It does not directly satisfy the revised requirement: The service must be reachable as a public internet application.
D:RFC1918 private ranges are not globally routed public address assignments. It remains inappropriate in the revised context.
Question 145
A VLSM plan must fit a 50-host engineering VLAN and a 12-host management VLAN into one /24. Which action MOST directly meets the stated networking requirement?
- Plan a /25 reallocation and migration without overlapping other allocated ranges.
- Assign a /27 network with 30 usable host addresses.
- Allocate nonoverlapping /26 and /28 subnets on valid boundaries.
- Give both VLANs identical overlapping /26 prefixes.
Explanation
Correct Answer
C:VLSM allocates differently sized segments efficiently while respecting network boundaries. This specifically resolves: A VLSM plan must fit a 50-host engineering VLAN and a 12-host management VLAN into one /24.
Incorrect Answers
A:This action responds to a later condition: Engineering devices increase beyond sixty conventional usable addresses. Address plan changes must accommodate growth and existing neighboring allocations.
B:This addresses another problem in objective 1.7: A subnet must host 25 IPv4 devices using the smallest conventional subnet with network and broadcast addresses.
D:Overlapping local routed subnets produce ambiguous destination ownership. The suggested approach is: Give both VLANs identical overlapping /26 prefixes.
Question 146
A VLSM plan must fit a 50-host engineering VLAN and a 12-host management VLAN into one /24. A colleague instead suggests: Give both VLANs identical overlapping /26 prefixes. Which finding MOST specifically explains why that suggestion is unsuitable?
- Overlapping local routed subnets produce ambiguous destination ownership.
- Address plan changes must accommodate growth and existing neighboring allocations.
- VLSM allocates differently sized segments efficiently while respecting network boundaries.
- A /28 provides only 14 conventional usable hosts.
Explanation
Correct Answer
A:Overlapping local routed subnets produce ambiguous destination ownership. This flaw directly concerns the proposed action: Give both VLANs identical overlapping /26 prefixes.
Incorrect Answers
B:This rationale belongs to a later changed condition: Engineering devices increase beyond sixty conventional usable addresses.
C:This explains why the recommended control works: Allocate nonoverlapping /26 and /28 subnets on valid boundaries.
D:This flaw concerns a different case in objective 1.7: A subnet must host 25 IPv4 devices using the smallest conventional subnet with network and broadcast addresses. The current rejected proposal is: Give both VLANs identical overlapping /26 prefixes.
Question 147
A VLSM plan must fit a 50-host engineering VLAN and a 12-host management VLAN into one /24. After applying the solution 'Allocate nonoverlapping /26 and /28 subnets on valid boundaries.', which observation MOST directly proves that the requirement was met?
- Subnet calculator checks show disjoint ranges and correct masks for both VLANs.
- The subnet inventory fits within the allocated /27 usable host range.
- The addressing plan provides distinct host IPs, gateway and a valid broadcast boundary.
- Approval is recorded for 'Allocate nonoverlapping /26 and /28 subnets on valid boundaries.' but no operational validation is performed.
Explanation
Correct Answer
A:Subnet calculator checks show disjoint ranges and correct masks for both VLANs. It tests the intended outcome because vlsm allocates differently sized segments efficiently while respecting network boundaries.
Incorrect Answers
B:This observation is for a different condition: A subnet must host 25 IPv4 devices using the smallest conventional subnet with network and broadcast addresses. It does not directly test the target outcome: A VLSM plan must fit a 50-host engineering VLAN and a 12-host management VLAN into one /24.
C:This test addresses a separate problem: A data segment must contain 60 ordinary IPv4 host addresses without using special point-to-point exceptions.
D:The missing direct test is: Subnet calculator checks show disjoint ranges and correct masks for both VLANs.
Question 148
The original case was: A VLSM plan must fit a 50-host engineering VLAN and a 12-host management VLAN into one /24. The requirement then changes: Engineering devices increase beyond sixty conventional usable addresses. Which revised action BEST meets this new condition?
- Allocate nonoverlapping /26 and /28 subnets on valid boundaries.
- Plan a /25 reallocation and migration without overlapping other allocated ranges.
- Give both VLANs identical overlapping /26 prefixes.
- Subnet calculator checks show disjoint ranges and correct masks for both VLANs.
Explanation
Correct Answer
B:Address plan changes must accommodate growth and existing neighboring allocations. The revised requirement is: Engineering devices increase beyond sixty conventional usable addresses. The appropriate action is: Plan a /25 reallocation and migration without overlapping other allocated ranges.
Incorrect Answers
A:This is the original control. VLSM allocates differently sized segments efficiently while respecting network boundaries. It does not directly satisfy the revised requirement: Engineering devices increase beyond sixty conventional usable addresses.
C:Overlapping local routed subnets produce ambiguous destination ownership. It remains inappropriate in the revised context.
D:Subnet calculator checks show disjoint ranges and correct masks for both VLANs. The current requirement is: Engineering devices increase beyond sixty conventional usable addresses.
Question 149
An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65. Which action MOST directly meets the stated networking requirement?
- Recalculate network, usable host and broadcast boundaries before changing the mask.
- Recheck the gateway against the /27 subnet boundary and configure an on-link gateway.
- Allocate a /26 IPv4 subnet with 62 conventional usable hosts.
- Assume a default gateway outside the connected subnet is directly ARP-reachable.
Explanation
Correct Answer
B:The /27 containing.62 is.32 through.63, so.65 is on a different subnet. This specifically resolves: An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65.
Incorrect Answers
A:This action responds to a later condition: The segment is migrated to a larger prefix encompassing both addresses. A larger prefix alters membership and may allow a different on-link gateway.
C:This addresses another problem in objective 1.7: A data segment must contain 60 ordinary IPv4 host addresses without using special point-to-point exceptions.
D:An ordinary host cannot ARP for an off-link gateway under standard subnet rules. The suggested approach is: Assume a default gateway outside the connected subnet is directly ARP-reachable.
Question 150
An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65. Which TWO entries together specify the appropriate corrective measure AND the strongest direct evidence that it works? (Select TWO.)
- The host reaches its gateway after using a valid address in its connected subnet.
- Assume a default gateway outside the connected subnet is directly ARP-reachable.
- Recheck the gateway against the /27 subnet boundary and configure an on-link gateway.
- Allocate a /26 IPv4 subnet with 62 conventional usable hosts.
- Recalculate network, usable host and broadcast boundaries before changing the mask.
Explanation
Correct Answers
A:Correct verification. The host reaches its gateway after using a valid address in its connected subnet. This demonstrates the outcome expected from: Recheck the gateway against the /27 subnet boundary and configure an on-link gateway.
C:Correct control. The /27 containing.62 is.32 through.63, so.65 is on a different subnet. It addresses the present requirement: An application server is assigned 192.168.80.62/27 while its default gateway is configured at 192.168.80.65.
Incorrect Answers
B:Incorrect control. An ordinary host cannot ARP for an off-link gateway under standard subnet rules. The inappropriate proposal is: Assume a default gateway outside the connected subnet is directly ARP-reachable.
D:This control fits another scenario in objective 1.7: A data segment must contain 60 ordinary IPv4 host addresses without using special point-to-point exceptions. It does not directly verify or implement the present issue.
E:This is a response to a different later requirement: The segment is migrated to a larger prefix encompassing both addresses. A larger prefix alters membership and may allow a different on-link gateway. It is not the original control-and-evidence pair.